My GMC Sonoma 2.2L 2WD is running fine, except for a strong
smell of fuel after I shut the engine off.
I just had a tune -up, but it was occuring before and
still occurs every time.

i happened upon a posting in another NG concerning brake lines. the upshot
was that we all need go out and replace our factory installed rubber brake
lines with stainless steel braided teflon lined hoses because they do not
flex with application of pressure in high temps, repeated ...

I'm looking to buy a '98 or newer truck with the 7 1/2 ft. bed.  Prefer
4 cyl. manual trans.  Must have A/C & tlt wheel.
Under 60,000 mies, any color but white.  No work trucks please.  I'm
willing to travel out of N.E. for the right truck.  Please e-mail if you

Today is Monday the 30th (for time reference)
My 91 Sierra 5.7L has 156,000 miles on it,  the oil pressure gauge on the
dash has been on the low side for obvious reasons.  It has never gone into
the red zone just a couple of notches on the gauge before the red zone,

Why should a mechanic charge you $40 to diagnose a problem when you told
them exactly what was wrong, and they simply verify that you were right
seems silly to me.

I want to purchase an S-10 to plow my midsized driveway.  It is too small
for a large truck and a snowblower takes 2 hours because I am surrounded by
neighbors.
I live in Boston, so my driveway is about 7 feet wide.

GM IS CHEATING THOUSANDS OF THEIR HARD EARNED MONEY, LEAVING MANY STRANDED &
IN FINACIAL DIFFICULTY, WARRANTEE COMPANIES ARE GOING BANKRUPT TRYING TO
KEEP UP WITH EXTENSIVE REPAIRS FROM FAULTY GM ENGINEERING.
3.1 lt. & 3.4 lt. ENGINES ARE LEMONS IN ALL MODELS

Hello to all, I,am thinking of buying a Silverado 1500, 2002 or 2003
with a trailing package and a 5.3 v8 and I was wondering if there was
any thing I should be aware of good or bad. Any comment would be greatly
appreciated. Thank you.......Ed

Does anyone know where you can get kits for rebuilding alternators.
TIA
Corey

Just had a TBI---350 CI built with all the Edelbrock good stuff,
heads, intake,cam,headers and so on. The mechanic that installed the
new heads said that he thought roller rockers don't have that much
benifit if you are not running high RPM. What is this groups thoughts

I have a 1998 Chevy K1500. The brake lights don't work, the two back tail
lights and the light on the cab roof. I replaced the bulbs and that didn't
do it. Check fuses and they are O.K. The brake lights are the only thing
that I noticed that doesn't work. Everything else seems fine ...

Hey all,
I 've posted a few times when i run out of ideas so I thought i'd try it
again.  78 chevy 1/2 ton 4x4, has a vibration at 35 mph when you
brake/accelerate/coast through it.  if you brake hard, it does it worse,

 What is with all the spam lately?
It never used to be like this.

I'm trying to wire up two utility lights as auxilary back-up lights on my
truck. I would like to do it through the trailer hitch so that I can remove
them easily.  I have them all hooked up but they seem very weak. If I
disconnect one of the lights the other brightens up quite a bit ...

i have a 95 explorer,when i start it and put it in drive sometimes it will
not engage,acting like its in nuetral.
other times it will go 10 or 20 feet and then ,what seems like its in
nuetral again.