My Suburban has had an intermittant stalling problem for about 2 months.
I have replaced the fuel filter, fuel pump relay, cap, rotor, plugs,
coil, crank pos sensor. Checked the battery connections. Also did some
other 100k miles maint listed in the manual.  

Anybody own one?  Looking for a new 1/2 ton crew cab.  Nissan and Ford seem
to be the best of the options out there.  Hate to park one of those next to
my 91 Silverado though, but the GM versions seem an afterthought.

89 S10 Blazer 4.3 4x4
Applied park brake this afternoon and now it will not release.  Right
now it's all the way in and it will not release.  Have not ever worked
on brakes, any suggestions?  Thanks in advance

Wondering if anyone else has had a bunch of problems with these trucks or do
I just have a lemon ??
It's a 2002 with 6.0 liter engine, 12000 miles, engine knocks, rear end
noise, lots of ABS problems, now doors won't lock and key reminder chimes

has anyone ever used the matt tracks ?
http://www.mattracks.com/
here they are fairly expensive

Canadian Tire has the following on sale:
     The Inova 3100 code reader makes it easy to quickly retrieve stored
diagnostic information from your vehicle's computer memory.
       a.. Easy to use and view with no complex, multiple screens;

I am about to switch from BF Goodrich All Terrain T/A to Canadian Tire
Roughrider M+S and i am wondering if this is a good idea?
I know the M+S are a more aggresive tire but they are much cheaper $160
compared to $230 and living in Edmonton anymore snow grip is good.

I have a 99 1500 Silverado with a minor blinker problem.
The right turn signal works properly, but the left turn signal blinks at 2x
the rate it is supposed to. I tried (Just for kicks) replacing the fuses for
the left turn signal in the box under the hood and it did nothing. Same ...

I need help with my truck, 1994 k1500 z71.  Every time I pull a trailer it
blows the turn signal fuse.  It has blown with different trailers.  Blows even
when I dont use my turn signals.  Where should I start?  I've looked over all
the wiring I could see underneath the back and ...

http://www.internationaldelivers.com/site_layout/severe/cxt.asp
Holy sheep-sh*t!

   is there a convertion for Geo tracker so i don't have the lock out
hubs......  because wth the lock out hubs i'm limited with what kind of
rims i can put on it.   I want to put 17" Chrome spinners if they will
ft 7 spinner whees don't have large centers.

I recently had the opportunity to purchase a '97 Yukon SLT 4x4 with 108K
miles.  Truck is really clean and seems to run well.  The owner was asking
$11,800 and I offered him $10,500.  He declined but I told him to call me if
he couldn't sell it for more.  Well he called me today. ...

Thanks to good advice I received from Marsh Monster, Brian Onion, and
others, my transmission is working again. I wound up sending the tranny to
a specialty shop for a rebuild. It is now reinstalled, and works better
than before I fried it.

Hiya!
Anyone know of a good source for weld in cab parts.  Looking for floor pans,
lower door jam, and foot well parts. All advice welcome!
Thanks!

I just purchased a set of Hermoff  6123 and 6124 manifolds for my 1994 Chevy
truck. These manifolds have a hole for a AIR emission device which my truck
does not use. What do I use to plug these holes on my application? My local
autoparts store where I purchased these items was ...