Hey all.  I've got a question about a problem that I noticed last night
with my new truck.
I was out and about, and I noticed that the friction point of my clutch
changed, and to get it to idle I had to push the clutch all the way to the

Just bought a Scramber 50 for the kids.  Has anyone ever fit one of these
into the back of a small SUV or minivan?
Brian

The other day my 99 envoy w/4.3 temp started to rise from the usual temp of
190. I added some coolant because it was low. Now a week later the temp shot
up almost to just under 260. I stopped and checked the coolant again and it
was full. I loosened the radiator cap a little and ...

i lost the site you guys have posted on here for the s-10 zr2 blazers
rpo codes, can someone please repost it for me,
its a 2004 blazer
thanks.

How do I repair subject leak?  I replaced the POS gaskets that came with the
Y-pipe with the Flowtech dead-soft aluminum gaskets and cranked them down
pretty good.  But I still have a leak.
Question:  Could a bead of high temp silicone be applied to both sides of

I want to try various paint schemes in Photoshop for a proposed paint
job on my '93 Burb.  Need Front and side views that have uniform paint
jobs- that is re-touched photos- so I can easily replace colors in
photoshop, and than add trim scheme I have in mind.

I have a 2003 Chevy Silverado 2WD, 4.3 V6 with a 4L60E transmission.
Traveling at a steady speed of about 40 MPH , and trying to maintain that
speed  I get a shudder/vibration. I was told that it is the transmission and
it is inherent with that truck.

I am rebuilding a 400 small block Chevy and was wondering which type of
lifters are best to use and what the advantages are between different
lifters.
thanks

When I post to this group from my pc at home the post does not show up
in this news group consistently. Sometimes it will show up after a few
hours and sometimes not at all.
Anyone else experiencing this problem.

Hi Folks, I have an interesting problem.
I have a 1984 Chevy Blazer 4x4 with a thm700r4.  The original engine
was a 305 and it was replaced, by the original owner,  with a Mr.
Goodwrench 350.  

The fan on my climate system seems really weak.  When I turn the dial
to one or two, hardly anything comes out, 3-4-5 have a little bit, but
not much.  It makes noise like the fan is blowing, it's just not
pushing any air.  This is really strange, because the rear controls/fan

I have a 2004 Yukon SLT with the 6-disk, XM radio. When I press the
Auto EQ button it cycles between Custom and Talk. When Talk is
displayed there is a EQ 1 in the upper right-hand corner. How do I
select a different EQ mode (other than Talk)?

When I pull on the outer door handle on my 97 S10 the frame or casing
that surrounds the handle and seals with the door sticks out a little
at the top.  I can push it back flush with the door, but then it pull
out a little the next time I use the handle.  Can I just take off the

Hey all.  I've got a question about a problem that I noticed last night
with my new truck.
I was out and about, and I noticed that the friction point of my clutch
changed, and to get it to idle I had to push the clutch all the way to the