Didn't get your thread on too much heat.  Can this problem be solved?

I'm thinking of buying one but I've heard they have problems with
manifolds - anyone know anything about this?
Thanks,
MZ

Well, finally got around to replacing the noisy water pump on my '93
C1500 W/T today.  When I was flushing the radiator out, I looked at
the filler neck and noticed that there was a constant stream of tiny
bubbles coming up out of the coolant whenever the engine is running.

I have no heat at all. No air come out the floor vent. When selector is
turned to the floor position , cold air comes out the defroster. Selector
position works for the dash vents and the defroster. I was told the heater
core was bad and mode actuator needs replacing which means ...

Can someone tell me the number of gallons each fuel tank holds?  Truck is a
1997 GMC 3500HD diesel.  Front tank is located between the rails,  to the
left of the driveshaft, and slightly behind the cab.  REAR tank is located
between the rails,  and behind the rearend.

1995, 4cyl with 5 speed.....
Since the bolts had broken off, I was wondering how I could find out if
there was supposed to be a shim in there??
Thanks

I know that on some vehicles you can swap parts with different makes
and manufacturers....eg:  sonoma and either nissan or toyota parts or
something like that..
Is there any vehicle out there where parts can be used on a 93

I've read much about how oiled surgical gauze type air filters (e.g., K&N,
etc.) allow fine black dust (white glove test) into the engine.  I've
experienced it firsthand on our 98 Tahoe 6.5TD.  I've also experimented with
wrapping about 10 feet of surgical gauze around the K&N ...

My cooling system is working fine now.
I'm back with another question.
When ever I park my 99 envoy with the nose slightly lower than the back end
the "Service 4 wheel drive" light lights up. I'm almost sure(although I

   I know this is a chevy message board but I am looking at a 96 Chrysler
Sebering, but the battery on it is dead and the door wont unlock because the
battery is dead, anyone of you know how to move around this problem? I
havent looked at the hood to get it open and I  could ...

Talked to Edelbrocks tech department yesterday, when you use thier MPFI
manifold you use the stock throttle body.  Specs say it is 1 and 5/16"
higher than stock, so far so good. I was having a slight problem with the
Proform case fitting all the way around (it was hitting the MAP ...

Chevy 1980 G30 Sportsvan, 5.7, TH400 etc etc
I kinda forgot (me lazy) to check the brake fluid. So one day I drove it
and lost pedal and the BRAKE warning light came on. I thought this would
be a great moment to flush the system. The problem is the bleeder on the

Hi All,
I put a 350 in my s10 and enjoy the additional power.  The problem I have is
that when I am pulling a trailer the allready marginal brakes are not up to the
task.  Does anyone know of an after market brake improvement that is designed

I have a 2002 S-10. 68,000 miles and I need a fuel pump. I have been hearing
now that this is common. What is the problem with them? My 2000 S-10 had
automatic transmission problems that now I hear are endemic with them
(clutch going in and out like shuddering, then the ...

Saturday, I'm venturing down the I-81; Watertown NY to Syracuse to
Binghamton to Scranton PA, then slipping into NJ, ending up at Clinton;
going to pick up some old Ford parts. Along the way I'll be looking for
parts for my new ride; my '89 Suburban. I really need a new grille, and