Hello All;
I recently bought a used '03 K3500 with the 8.1L...this truck was originally
sold in AZ and did not come with an engine block heater (go figure)...has
anybody installed one on a truck like this??...the dealer told me that it

 I paid $7250 for it, a good deal?
 Also, anything I should be on the lookout for in it?
 I gave it the best gas for it's first fillup, Shell 93 octane.  35 gallons
and $70 lighter now, I'm debating between high mileage or full synthetic

When I'm cruising down the interstate, what is the best engine rpm for
best fuel economy assuming level roads & little or no load in the
truck?
Thanks

Well gentlemen, my new 350 is in the engine compartment, Edelbrocks MPFI
manifold is on, new EGR valve, new PCV valve, new higher capacity fuel pump
is in the tank, new TES headers are on (the preheat tube has been plugged),
new chip is in the computer, new plug wires, new ...

Can someone help me out here? I have an 88 k2500 that the power windows and
locks quit working and now I'd at least like to get the windows to work
again. The locks quit about a year or so ago when I think the button stuck
and possibly burned the motor up. The windows have been ...

Anyone ever replaced them? they are on the driver side next to the oil pan
and look impossible to get to.  Looks like the o ring is going out on it. I
had the lines and the ring replaced 2 years ago.
Are there any tricks to make it easier to get the o ring out and replaced?

Good afternoon everyone,
   I have a 99 Chevy Silverado Z71 4x4 Sportside.  I need some help.  I
recently purchased some white faced gauges for my dash.  The instructions
that have come with are not of any help.  I am wondering how do the gauge

Is it common for the intake to fail / break so as to dump coolant into oil
pan?
Is this because of the synthetic material it is made of?
If so what are the dangers of damaging the engine if it is only run for a

can anyone give me some advice please, I am in uk, and I have an 88 R20
suburban 454ci with a thm400 autobox, problem is my speedometer became
"jerky" at over 50mph this lasted for some time then it stopped working
altogether, I obtained a new cable and fitted it but this didn't ...

I have a 1999 Silverado 2500 series pickup with the 6 liter engine. I have
19000000 miles on it. The service engine soon light came on today. Is there
a way to run the codes with out taking it to the dealer. Or what would I
check first.  thank you

Hey, I was just wondernig. The 3400 SFI V6, is it supposed to make weird
noies while running? Such as lifters and such. I have heard other 3100's and
3400's make the same noise. I was wondering if this was normal and what
causes them to make these noises.

Dies anyone know where I can get a stock PROM chip for an 89 3/4 tom 350
automatic Suburban!?!?   I tried one of the superchips,  but kept getting
codes on my check engine light saying it is a read error (flashes
constantly).  I ruined the original trying to get it back into the ...

Any news on when Chevy will come out with a new Silverado.  I would like
to buy a new truck but would wait a little while if an update were in
the works...
Thanks,

Coming into some money next year and want to tow about 7000lbs.I test
drove a 1/2 ton with the 5.3 and it seemed like tons of power.I notice
that the new 3/4 ton only comes with 6.0 or larger.Is the 5.3 adequate
for my towing needs?If so I may get a used 3/4 with the 5.3 and the

HI I have a 2002 Trailblazer I was under the SUV and did not see a grease
fitting any where under there do anybody out there know where I should
grease it or I don't need to grease anything under there or doe it have a
different type of grease fitting? thanks for the help.