I have a 1994 Pickup,1500-5.7  I was on a trip and used the cruise going
there with no problem.On the way Home I went to use the cruise and nothing.I
kept trying many times.I looked incase it was a fuse ,I did not find one.On
the drivers side of the firewall there is a black box ...

Well I got the front hub apart an dthe clutch hub is broken, the problem is
that the dealer says it's no longer a vailable and NAPA does get that far
into the hub. Any ideas besides junk yards? It's an 87 GMC P/U manual lock
hubs

Anyone got any good ways to free up a seized bolt holding the
thermostat in place on a 350?  I have tried different types of
cleaners to help loosen it but none work.

1993 silverado sportside
The driving light/turn signal on the right hand side of the truck when
I turn them on flash fast like there's a short.  The book shows a
ground connecting to somewhere on the sheet metal but I just went out

I am shopping for a new (old) 4x4 Chevy.  The 4 that I have seen
already have all had blocks front and rear to provide the lift.
My understanding is that this is not a safe situation but I cannot
remember why exactly.

Howdy Gang!
I'm looking for some ideas...
In the near future I will be needing to replace my exhaust from the cat
convert all the way back due to rust and age on my 92 s10 blazer 4x4 v6

Weird one for you all!
I have a 97' S-10 Blazer 4X4. Yesterday I had to slam on my brakes to
avoid a yuppie crossing (Honda.) After that happened I turned around
and went back to educate this "gentleman." As I drove off I heard a

I have two questions.
When you start it you can hear a squealing or squeaky sound from the front
of the engine.  I cannot tell if it's the alternator, water pump or what.
It goes away after about 15 minutes of driving.  Is there any way to telling

C1226
C1225
C1221
C1233

Hi all i have a 98 K1500 the abs brakeing will come on around 6 mph the dealer said it is the pickup ring in the hub. there answer is to replace both front hubs at around $600 just for the hubs is there a less expensive way to solve this problem and can a guy do this at home with ...

I've replaced the thermostat 3 times, trying to get heat in the beast, and
in the process have replaced the temp sender.
No reading on the temp gauge...... 2nd temp sensor didn't solve the problem.
Does anyone have a schematic? I should be able to read the resistance of the

Based on the whine noise coming from the rear diff, I may be in
for a new ring & pinion for a 1994 S-10 Blazer 7.5" posi diff
(98,000 mi). What should I expect to pay an indy shop, parts &
labor, for repair ?? Denver area

A week or so ago, I had the intake manifold gasket replaced on my 1997 5.7
liter V-8 C-1500. The garage replaced the serpentine belt tensioner with the
claim that it was a good thing to do because the OEM tensioners fail and,
horrors, go into the radiator. It seemed like a good ...

I was wondering if anyone else that might have an 04 Silverado (5.3 LT.
engine)has experienced any problems with a hesitation on take off on a
cold start.  I have this problem everytime I start up and the dealer says
that they cannot find it.  There are no codes in the system and ...

I have a 2004 Chevy 2500HD crewcab with the diesel and Allison tranny and
recently bagan to notice some clicking in the steering linkage when making
slow, sharp turns (like in navigating in and around a parking lot).  I took
the truck to my local dealer and after looking at it ...