Under the front seats both floors are rusted pretty good all the way to the
rocker panel. I am trying to pull it out but I don't know where to cut it
off at, or what I should do to replace it once it is out? There is allot of
ideas floating around like pulling the floor out and ...

96 Silverado, 305, man trans, 133k miles
Ok, I replaced both O2 sensors in on the left side. I did not replace
the after cat one. I cleared the codes and the 0420 code came back. This
code is supposed to be cat efficiency. I cleared it again yesterday and

Howdy,
   Moved to North Dakota from Kentucky and am looking to put a block
heater on my '95 S-10 with the old 4.3L V-6.  I bought a heater that
goes into a freeze plug hole.   Now, as far as freeze plugs go, I know

This morning when driving the 1997 Chevy into work I did the usual.  Start
the car up and put it in the Drive (overdrive) as I have the following
selection: P ­ R ­ N ­ O ­ D ­ 2 ­ 1.  I left the house and I was doing
about 45 mph when the car engine continued to rev but car was ...

I just pulled a very good working 305 TBI out of a 1988 Chev truck 2WD, and
put it into a 1987 Chev Silverado 2WD. After hooking everything back up on
the Silverado, the truck fired up right away. It ran great, up until it got
to operating temp. When I try to drive it, it starts ...

I have a 203 transfer case mounted to a 350 turbo,when i accelerate it kicks
the transfer case out of gear.I have removed the linkage to see if it is not
fully engaging on the shift but it appears to be any suggestions??
Scott

I have a 01 Blazer with the stock Laredo AWR's on them, they were OK never
had any problems in snow or rain.  Thinking of getting the Cooper Discover
H/T's or A/T's as replacement.  Anyone have any experience with these tires?
Thanks

How do I reset the computer on a 1987 chev silverado?
Thanks
Mike

  I need to change my rear rotors on my chevy s-10 4x4 4.3 - I recently
changed the brake pads and know that a rotor change is in my immediate
future.  I've done drum brakes before, but never rear disk brakes with the
internal parking brake.  My Clymer isn't a whole lot of help...

Fellas,
It's happened three times in a row so I know it wasn't just a fluke.  I
recently switched from using M1 oil filters to AC Delco oil filters in my
truck.  After every oil change, for the first 5 or so cold starts, I get

I have a squeal coming from the rear end on acceleration. It's noticeable
from start until about 30 mph. A friend mentioned it sounded like it was
coming from the left rear so I checked and noticed some oil around both
hubs. So I changed the rear axel seals. The problem is still ...

I am looking for a carberated chev 305, or 350,  no computer stuff,
electronic ignition ok.
Dan

My wife has a '95 Chevy 1500 truck.  The voltmeter normality reads right at
14 on the gauge.  Just the other day the gauge started to read lower, 13.5
or as low as 13; if I am reading the gauge right.  My wife is concerned
about this, however the truck starts and runs fine with ...

BlankQuestion: Chevy 307cu.in. 220 Hp. Does any one Know the recommended CFM for this engine. There is a quadrajet on there now and was thing about going to an edelbrock. Input will help.      Ted

Hello all, I have a 99 Silverado 1500 4x4. According the RPO codes I have
the G80 Locking Rear diff with the 3.73 gears.  The blue tag on the diff
calls for 75w-90 Synthetic, so I bought the Mobil1 gear oil.  I'm
wondering do I also need to add some sort of anti-slip additive?