Hey all,
got a 99 silverado z71, washer fluid pump went out, the container's under
the batter, do i have to take it all out or can i reach it from the bottom?
is it inside the container or on the bottom?

I needed a batter for my 1994 Chevy C1500,5.7L.
I went to several different Auto Stores.My question is each store according
to their computers suggest a different battery.
The cold cranking amps and cranking amps,differ from store to store.

Settings 1 & 2 on my Heater Blower are dead but 3-5 still work. Has anyone
experienced this problem?  Is it a problem with the selector switch or a
problem with the blower itself?  How difficult of a repair is this?
Thanks In Advance,

Hopefully one of you out there can help.
I have a 2001 Suburban, and I am having a problem with moisture accumulation
in the carpet on the passenger side front floor board and second row
floorboard.  I've inspected the door gaskets and they seem fine.  Any

 Whats  the  best  way  to  store  my  summer  tires?  (rims and tires)
They  are  in  the  basement.
Thanks  for  the  opinions
Steve in Ct

Wondering if anyone can point me in the right direction for a replacement
yoke for a 1960 chev 4x4 . Need input shaft yoke on a Rockwell transfercase.
Thanks!

2002 5.3, auto, z71 set a code P0440 yesterday on the way home.  I think
this is the one for a loose gas cap????  Checked cap, was tight and I took
it off, looked for crud, nice and clean.  Any suggestions.  Tx  Mike

I have a '00 K2500 Suburban diesel and want to get an impact wrench to help
when rotating the tires.  I know the proper torque is 140 ft-lbs.  What
capacity air impact wrench will do the job?  I thought 350-400 ft-lbs would
be OK, but my BIL (similar truck) says it's not enough - ...

Hey guy I was just wondering if anyone else cam e acrross this
problem...........
I have a 84 chevy 4x4 all done up mechanically..........
msd ignition ......

thank you guys for all your help. much appritiated...
hey just wondering what are you askin for christmas? or what do you want??
is offroad stuff better then tools or are there even better gifts out there
what else can you get a man!!!

When the AC cycles on the pulley makes a grinding noise that vibrates the
truck.
When the pulley is not spinning it is quiet.
Is the compressor gone, needing replaced?

OK, since you've got some diesel guys in here...
I bought a 2005 2500HD, Diesel, 4X4 crew cab short bed with the Allison
automatic about 2 months ago.  Replaced a Dodge 5.9L, 1/2 ton auto...
We put 500 miles on it then hooked up the small 5th wheel and made a couple

I have a 2001 Tahoe with about 70k on it.  Yesterday, when engaging 4 Hi on
snowy-icy roads, the front end started making a grinding-howling noise.  It
goes away when put back in 2wd and also makes the noise, although not as
bad, in Auto.  I drained and refilled the front diff.  ...

hello gearheads,
i got myself a set of lifters ( hydraulic) of ebay, they are new taken out a
small block crate motor.
when i got them home the i found that instaet of being round they have a

Hey all,
just bought a 99 silverado with the 5.3 v8.  Anyway, i was chugging down I59
last week and saw the temp gauge go up to almost 210 degree, just a little
lower, but i was going about 80-85 mph..is this acceptable or do i need a