| Thread | Last Post | Replies |
|
| 98 Tahoe 4x4 Problem | 15 Dec 2004 08:25 GMT | 4 |
Hi new to group, I have a 98 Tahoe that up until two days ago ran great! It has lots of Km's on it (250,000). This is the prob, I was running in Auto 4x4 (snow up here in Canada) everything just fine, went to back out of drive way and notice rear wheel spin, looked down and panel ...
|
| Daylight Running Lights.... | 15 Dec 2004 04:51 GMT | 3 |
Not working. '96 Silverado. Diesel. Lights come on with the switch only. The light on the dash (for daytime running lights) is on. I've checked all relays and fuses.
|
| New stat...same problem | 14 Dec 2004 23:17 GMT | 4 |
Hey guys, I posted a while back about an overheating problem. My 89 Suburban was purchased in the spring. It warms and idles fine but at speeds of 40mph+, even while cruising, it will jump in temp from 180-190 to 260+. It stays maxed for a few secs then returns to normal operating ...
|
| 1987 C30 Radio Problem | 14 Dec 2004 16:56 GMT | 2 |
About 6 months ago I bought a 1987 C30. The AM side of radio has static but no signal. The FM side seems to work OK. Does it have separate antennas?
|
| ABS Question on blazer | 14 Dec 2004 13:05 GMT | 4 |
ok this morning I started my 99 blazer when I got 2 doors down the street my ABS light came on. While that light was on my trucks speedometer didn't work at all nor did my transmission. It was suck in first gear going about 15
|
| Duramax Diesel | 14 Dec 2004 06:21 GMT | 6 |
I have recently purchased a 2500HD 4x4 with the Duramax Diesel & a 6sp tranny. A recent post asked about synthetic oil. I personally recommend Red Line. You can see their products at http://www.redlineoil.com/ I use
|
| Stripped Spindle Thread Help | 14 Dec 2004 04:19 GMT | 5 |
I have a 1979 Chev K10 with front wheel locking hubs. The locknut and spindle thread (at the outer edge) has been partially stripped. The thread that is not damaged is still usable. I cannot remove the inner adjusting not because of the stripped portion. I have
|
| gauge cluster bulbs | 14 Dec 2004 04:04 GMT | 1 |
87 K5 5.7l TBI 700-R4/NP-208 4" Tuff Country E-Z Ride Springs and many many other mods
|
| Lifting a Coloarado | 13 Dec 2004 17:30 GMT | 7 |
Ok, I admit it. I should have bought the Z71 version. I have the one i have now though, so now I need to lift the truck. The rear should be no problem. I want to add a couple leaf springs for capacity so I can just have them re arced at the same to give me how ever much lift I ...
|
| Tire/Rim size important? | 13 Dec 2004 15:08 GMT | 12 |
Stock tires on my '04 2500hd are Lt245/75 R16 on a 6-5/8" wide rim. I would like to put Goodrich All Terain T/A 265/75 R16 tires on these rims but the 265 tire specs call for a rim 7" - 8" wide. the difference in tire diameter between these tires is 1.2".
|
| P0430 Cat efficiency code, Help | 13 Dec 2004 11:24 GMT | 2 |
I know by having the computer scanned that this code is pass side cat efficiency issue.. I hear its most likely the o2 sensor, possibly the cat itself. What are the chances its the cat.. If it wasnt for the cost factor Id just replace all 4 o2s and be done with it.
|
| Stock Battery 2002 Silverado 5.3L | 13 Dec 2004 03:53 GMT | 6 |
Just had to replace the battery and the truck is only ~ 2 years old the "stock" battery was only rated 600 CCA. Even Autozone recomended min 650 CCA and I went with the 800 CCA . Now what's wrong with this picture.
|
| Tire pressure | 13 Dec 2004 01:37 GMT | 22 |
Hi NG I need help about air pressure in my 285/75 R16 tire. On my 97 Tahoe 4x4 I have some BFG AT 285/75 on 16x10 MT Classic II rims. But what should the tire pressure be at normal driving? Some say it has
|
| 04 K1500 Spark Knock | 13 Dec 2004 01:32 GMT | 4 |
04 4x4 Ext cab Short bed It's a 5.3 auto, 3.73 gears Purchased Oct 18 with 24 miles. It now has 5600 miles on it. Spark Knocking like crazy.
|
| valve seals | 13 Dec 2004 01:25 GMT | 7 |
The valve seals on a small block look like "O" rings that go around the valve stem. Do they go in a grove on the stem below the keeper groove or do they ride down on the valve stem near the head? I should know the answer to this but somewhere along the way I forgot!
|