| Thread | Last Post | Replies |
|
| 1995 wipers | 11 Jan 2005 23:38 GMT | 7 |
Does anyone know of a mod I could do to my K1500 Z71 mist wiper circuit? Whenever the mist lever is used, the washer pump applies fluid & stops wiping after 3 cycles. This seems to be 1 cycle too many - it streaks the windshield wickedly everytime. Might sound anal to some but ...
|
| 4L80E Hard 1-2 Shift, 91 R2500 6.2 | 11 Jan 2005 22:06 GMT | 2 |
I've got a 91 R2500 Suburban, 6.2 diesel with a 4L80E and 116k on the clock. The truck has not been driven since October on a 70F degree day at which time it shifted normally from 1 - 4 (OD). It's been
|
| 1988 chevy g20 van ignition problem. | 11 Jan 2005 21:41 GMT | 5 |
Got the van a few months ago for dirt cheap and everything worked perfectly. About 2 weeks ago the ignition started acting funny. What I mean is the heater blower and windows would sometimes not work until I jiggled the key. Well, yesterday even this trick stopped working. Check
|
| 92 GMC 350 EFI oil pressure question. | 11 Jan 2005 13:21 GMT | 2 |
Recently the oil pressure gauge in my 92 GMC (350 efi) has been acting up, or the oil pressure itself has been acting up. Here is what's happening: After driving for a length of time (30 mins or greater) the oil pressure gauge will fluctuate. If the gauge reads low when I stop ...
|
| Nissan Titan | 11 Jan 2005 13:21 GMT | 14 |
Anybody try one of these out or own one yet? I took one out yesterday and am seriously considering dumping my piston slap happy GMC piece of crap for it.
|
| knock outs | 11 Jan 2005 13:04 GMT | 2 |
i called my local dealership about a four wheel alignment and they gave me two different prices one for an alignment and a price if my truck (1999 slverado) had knockouts. what is he talking about?
|
| Flashing 4hi light push button 4x4 | 11 Jan 2005 12:30 GMT | 3 |
I have a 97 tahoe with push button 4x4. I have known that my shift encoder motor is bad. It has been out for a while. When that happens you cannot shift into 4 hi but you still have 4 lo. Just today the 4hi light started flashing and has been all day. I checked the codes today ...
|
| Question about Transmission oil | 11 Jan 2005 09:59 GMT | 4 |
Was anything other than gear oil used in manual transmissions in Chevy full size trucks? I was told that some manual transmissions actually had ATF or other lightwheight oils in them rather then Hypoid gear oil.
|
| 98 Jimmy OEM fog lamps?? | 11 Jan 2005 04:53 GMT | 2 |
I just replaced my lamps with the new Sylvania Silverstar lamps and notice a port for fog lamps. (SS, what a difference, highly recommended) While the car did not com with fog lamps from the factory is it possible to install ( or replace assembly ) for this option? I have not ...
|
| changing climate controls | 11 Jan 2005 02:52 GMT | 1 |
I have a 2004 tahoe w/ the standard dual climate controll (two dials for fan speed and vent placement, and two sliders for driver and passenger temperature) I also have the over head control for the rear cabin. My Grandpa just purchased a 2004 silverado ext cab w/ the
|
| Factory Tow Hooks | 11 Jan 2005 01:28 GMT | 3 |
I am looking for a set of factory tow hooks for my 2000 Silverado. Two questions: 1. Do you know any place to get them cheap? 2. What years are the tow hooks the same so I can look at junk yards for a
|
| ABS light on 95 Suburban | 11 Jan 2005 01:06 GMT | 5 |
On my 95 Suburban 5.7, 1500 with 135k miles, the ABS light came on about a month ago and never went off. i think i only have rear wheel ABS. Any ideas what the problem may be? Chuck
|
| Ignition switch acutator rod fell off HELP!!! | 11 Jan 2005 01:05 GMT | 2 |
I was putting a new ignition switch on and I was being real careful not to move the rod too much (obviously no careful enough) but the rod just fell off and judging from the connector on the other end it really isnt bolted to any thing on the other side any way.
|
| 1996 Tow Rateing | 10 Jan 2005 23:59 GMT | 1 |
Does anyone know the tow ratings for a 1997 GMC 2500 extended cab 4X4 with a 454 motor.. Thanks Ryan
|
| 400 small block Chevy problem | 10 Jan 2005 22:22 GMT | 11 |
My son and I just finished up installing an 400 sbc engine in his '79 El Camino. Has a mild cam and an Edelbrock alum. intake. (Performer). When it's cold, it runs fine. After the engine completely warms up, it starts to miss and run very rough. The HEI dist. was working fine ...
|