Had a strange rapid clicking noise in the cab (90 gmc 1/2 ton Sierra 305)
down by where the firewall meets the trans hump. It sped up with the engine
so I started thinking clutch or bad bearing in the tranny (Getrag 5spd). As
I was under the truck with a wood stick to my ear, ...

I saw a post below about a failed evo sensor on the steering on a Chevy full
size.  My Jimmy seems to have "too much" power assist at highway speeds, and
therefore wants to wander.
I thought I must have a bad tie rod, etc., but I went over the whole front

On a 75 chevy 3/4 ton ,350, auto,2bbl,2wd I have headlight problems.I have
had the alternator checked by AutoZone and it checked out ok especially the
diode check.While I am driving with the headlights on they are dimmer than
normal,as I accelerate the rpm's the lights become ...

I have the above mentioned truck and the driver side door does not close
properly. It appears to have "dropped" down. It takes some serious force
for it to shut correctly, even more so when it's raining/snowing. I've
heard this is a common issue with GMC, but not sure what is ...

 I have a small question.  The volt gauge in my 91 suburban has started to
read low, about 12.8v.  I have check the battery with a volt meter and see
14.2v w/ nothing on except for the engine running and 13.9v with all the
accessories running.  So that tells me that the alt is ...

I have a 1989 S-10 with a door hinge problem.  The top door hinge was never
lubed properly and the pin or sleeve has rusted through.
The door droops now and is hard to close.  Has any else had this problem?
How is fixed, how hard to fix, how much does it cost?

I have a 68 GMC that I just put a 350 eng and a Turbo 350 Trans into.  It
had a inline 6 and a 4 spd manual.  Its a short bed truck.  I need a drive
line, does anyone know off the top of there head if there is a drive line
that I can use from another vehicle?  Or maybe the proper ...

'97 Sierra 1500 4x4, 90K miles, good, new tires. The lugnuts are tight.
When I start a gradual right turn, at slow speed, I suddenly get a
slight softness in the steering wheel, and a little more vehicle turn
than should happen - requiring a slight correction to the left.

my 1991 S10 failed its NJ vehicle inspection
HC fail  reading 246
CO% fail  reading  9.52
any help as how to get it to passed.

What are the opinions out there about tanneau covers?  Is the hard foldable
one the best or are the cheaper soft ones with square snaps or other types
just as good?

 This is scary.  I think it may be connected to the cruise control somehow.
The truck speeds ahead  when I use the left turn signal, and the brakes
won't stop it.  It's done this once.  Other times, it quits with a tap of
the brakes.   I just bought this truck and am in shake down ...

I have a 2004 Tahoe LT with memory seats that fail to recall the set
positions.  In fact, it randomly chooses a position each time I get in.
Chevy verified the problem and that they have unable to fix the problem.
It doesn't look like they will figure it out at all.

Hey everyone
I have a 2000 silverado with the 5.3 L in it.  The truck has the 26 gal.
tank (reg. cab, 6 ft. bed) in it.  Sometimes when I start the truck, the gas
gauge on the dash will read empty (even though there is plenty of gas in the

Have a problem with my truck starting it turns over has spark and gas but
will not fire. At times it misses like it is out of time and turns over at
a high rate of speed. Does anyone have any suggestions as to the problem as
I can't get it to a service station. Thanks

I'm wondering if someone could help me. I'm looking at buying a Jeep
Cherokee with a 2.8L
but will not start and the guy said that the starter is out of line and
tends to jump out of line. So if anyone knows anything about this please