04'  2500 HD 6.0  
What mileage does everyone recommend I change my tranny fluid the first
time? Should I just have it flushed,or do the filter to?
I never like to go by the manual.

Ok guys heres a Fun one.
I've got a 1992 Chevy Blazer S-10 Tahoe 150,000 Miles.           4.3l
Mutliport fuel injection I think its a "w" vin #
Will not start just Click, Click, Click.

I know this is off topic but I'm hoping someone has one of these laying
around.  I need to convert a lot of old Beta Player (BetaMax) tapes to DVD
and I need to buy a player from someone.
If you have one or know of someone who might be interested inparting with

Hello, my question is, which transmission fluid is better when towing a R.V.
trailer, synthetic or regular. I have a 98 Silverado half ton and a 5.7
engine and I am due to change the fluid and was wondering which was better.
Thank you.............Ed

I'm swapping out my old '77 350 with a 454 from an '86 suburban.
The 454 has wide pulleys for a wide serpentine type belt on the crank,
alternator, water pump and smog pump. AC and power steering run off a
V-belt from the crank.(V groove pulley is behind the wide pulley on

Can a nv3500 be bolted up to a early 80's 350 or are the bolt patterns
differnent?

any help with a misfire in cylinder 1 and 8. changed distubuter,distibutor
cap,rotor,plugs, wires,injectors,fuel wire harness still a misfire on 1
and 8. No codes on computor. Compression fine, thinking possible ecm.

I've got a 2002 Ford Taurus with about 47k miles on it.
I started the car up after work, got about 10 feet and it started running
really rough, then stalled and wouldn't start back up.
This morning I put about 3 gallons of gas into the tank (it was nearly empty

I am debating on having my crank turned or buying a new one for 125 bucks.
My problem is I purchased new rods for my SB 400 and they are the 5.7 that
use the pistons with the moved wrist pins.  Can I use my stock crank with
the rods.  I am thinking I can because the newer cranks ...

OK, I called the 4 closest dealers and the results are:
#1. our techs use the PF 59 'cuz it's just easier to hand-tighten due to
added length-shouldn't be a problem with it's use...
#2. can use the PF 59 but prefers the 46 due to internal differences, i.e.

I have a 99 GMC Sierra 1500 w/5.3L with 98k miles. Has anybody experienced
problems w/the top dash and floor level vents becoming inoperable?... they
don't blow regardless of the fan speed selection, recirculated / fresh-air
setting, or the temp. control setting (hot or cold). All ...

OK, help me out here guys. I went to an Autozoned earlier today and bought
what their book says is the correct Bosch oil filter, a  p.n. 3332. Well, I
thought it looked way too small so I also looked up the Mobil 1 filter. It
said to use part number whatever(MOT-1-I think) and ...

With the lights on my alternator is only providing 12.6 Volts across the
battery terminals at idle.  At higher RPMS it's fine. Does this mean that
the alternator should be replaced?  Also I have been getting an intermittent
check engine light. Any ideas on what would cause that?

http://users.eastlink.ca/~mikemcneil/index.htm
-----------------------------------------------------
users trucks from this group listed below
-----------------------------------------------------

I got a 2005 GMC Sierra SLT Quadrasteer 4x4 with lots of extras. Leather, XM
radio, On-Star, bunch of buttons on the steering wheel.
Awsome truck.
Jim