i am doing to v8 conversion on a 1972 chevy l.u.v. truck. i have brodix
track one slant plug heads. and am have a hell of a time finding headers
that will work. the hooker heads for the luv v8 conversion dont work. has
anyone been successfull with headers and the luv truck?

I want to install a set of Dynomax headers on my 1972 Chevy with a 350. It
has a 4 speed Muncie with the linkage connecting to the block. wil there be
clearance issues?

My 2000 Short bed Z71 is finally ready to retire the Firestone
Wilderness 265-75x16 tries. Sams Club has Michelin X LT
285-75x16 tires for only $20 more for the set of 4.  I know the
wider tire will look better and it will alter my speedometer

Has anyone been to the Trailblazer club website?
http://www.trailblazerclub.com

You know the story, a '99 5.7L has 79K miles on it and is beginning to lose
coolant!!! Changed the oil this evening and discovered white streaks
trailing down the front of each side and along the bottom of the oil pan and
a closer look shows white powder on the front half of each ...

I have a 98 Tahoe sport, I guess it is the Z71 package? But I have had
the fuel pump replaced twice so far, then about 2 weeks ago it went out
again, well I banged on the tank with a rubber hammer and it crunk back
up fine. To it to the mechanic, they checked everything and said it ...

I'm looking for a tool to use to unscrew the drain plug in the manual
tranny in my '92 K1500.
The plug head looks like it will accept a 6-faced bolt head.  I've
created a simple bolt-based tool to remove the plug using a bolt and

I have an 86 Chevy Suburban that has recently started making a
clicking sound on the passenger side. It stops as soon as I press on
the brakes. Any ideas as to what it may be? I am new here and would
appreciate any help!

I'm replacing the speakers in an 86 suburban. I've already done the
back speakers (easily). I'm now doing the front ones, but I have 6.5
rounds.
Is there room in the door to put those in? It has power windows and

I'm trying trying figure out how much force is produced by a gas explosion
in a piston during a normal firing. The air/fuel is correct and the spark
and everything else is optimum. What is the usual pressure that is being
created to push down the piston? Say on a 350.

Going to do a cap, rotor, plugs and wires for my 99 1500 Suburban (350).  My
question is on the plugs.  The AC Delco brand was almost twice the cost of
the bosch plugs.  Is it worth the extra $20 for AC Delco's?  What is a
preferred plug used by the group?

I took the OEM deck out of my 2004 Canyon shortly after buying it.
My brother in law has a 2000 Sonoma, and his CD does not work.
Will my radio work in his vehicle?  I am primarily concerned with the theft
lock.  His took a user-entered code, mine uses a VIN.

I bought a used 2001 Savana 12 passenger slt last summer.  During the
test drive, I didn't notice just how hard and harse the suspension
was. (The test road was very smooth).
\

In another article, a guy on the diesel site ran an independent test on air
filters and their performance. Showed K&N had higher flow but also passed
smaller particles. This is a link to that site:
http://home.usadatanet.net/~jbplock/ISO5011/SPICER.htm

window wipers,overhead lites,radio,rear window wiper,no power but all fuses
good.