I want to replace my wiper switch on a 84 G.M.C van. I can remove the
steering wheel and the plastic cover then I'am stuck after that to get
any deeper.  Thanks in advance      robert erickson

So my order from etrailer has shipped and should be here soon.
As one who generally doesn't like rubber hoses and clamps, I am wondering
whether I should put copper or steel lines in place when installing the
cooler.  How much pressure is in the system?  Is there any reason why I

The van will periodically go haywire. It's fine one minute then all of the
sudden, it won't shift out of first gear, the power windows won't work, no
dash lights, no blower front or rear,and a couple of other things I can't
recall at the moment. It's got me stumped. I would greatly ...

  Long story, but here are the highlights.  DANA 44 axle, the pin that
holds the whole business together apparently came loose and broke about
1-1/8" off the end where the retaining pin/screw goes.  In the process, it
hogged out the hole in the carrier to an oval I can stick two ...

Hey all,
I've been posting off and on here whenever i get pissed off enough about my
truck to see if anyone can help.  It's a 78 1/2 ton 4x4.  At one precise
speed, approximately 33-35 mph, the thing starts to buck up and down. It's

Need help locating the fuel relays, can't find on the firewall, or one on
left front fender, or in the dash.  Need help, badly.  Send picture from
manual if possible.  Manual I own has none. Hoping someone can point these
out to me!  

I have a '95 Suburban 4X4 1/2 ton with 102,000 miles.  Engine runs great,
but truck has recently begun to vibrate ONLY while under acceleration, very
slight vibration while cruising.  Some folks have suggested that it's a
U-joint problem.  I am desperately hoping that it is NOT a ...

I know there are some parts firms out there like Year 1 for camraos for
trucks. Anyone got the webby?

fuel pump works, new filter,it's an 87 chevy silerado 3/4 ton "mud truck"
engine is a 350 TBI, need some suggestions

You might have to register to see it, but it's worth it!  Article pasted
below, photo on site.
Big Chris
http://www.startribune.com/stories/462/5175487.html

i'v a 2005 Mitsubishi L200 Storm EVO.
im looking for 10' BodyLift.
Thanks to all who respond.

I have a '96 Tahoe that squeaks and jerks every time I stop or start. The
dealer tells me that it is a drive shaft lubrication problem, where the
drive shaft yoke slides onto the transmission output shaft. After spending
$750 of my money, the dealer now tells me they don't know ...

I just purchased a 94 turbo diesel 133,000 miles for 3000 dollars. I
felt this was a pretty good deal. It's a straight drive truck. My
question to you guys is what's the best bang for the buck power and
mileage wise for these diesels. Chip or exhaust system? I know which

99 GMC Suburban just turned 100,000. When it is cold it makes a fairly
distinct tapping noise when first started. The sound increases/decreases in
concert with engine speed, and stops after about 30 seconds. It only happens
the first time the truck is started each day.

I have a 94 GMC 4x4 1/2 ton Sierra with a soft or mushy brake pedal.  My
older 84 GMC was the same way. I tried everything with it to stiffen up the
pedal but no go.  I've been reading that this is  "normal"  for the GMC.
And has been corrected on later models.  Does anyone know ...