Have a '72 bench seat in need of restoration.
In the LMCtruck.com catalog it describes my seat "Full Foam Back With
Spring Core Bottom" from the 67 to 72 era, and indicates that
replacement bench cushions for this type of seat are not available.

I was at a chevy dealer and the mechanic said you shouldn't put remote
starters on blazers, that he's seen problems.  I have a 2001 Blazer and I
want a remote starter on it for winter, I have one on my 97 Chevy Lumina and
it is great.  Any reason for not having one on a blazer, ...

I need to know how do I replace a blown brake lamp (left side) on my 2001
1500 Suburban.
Thanks in advance.

I have been told by numerous Chevy dealers across the U.S. that my part (a
rear window air reflector #12344262) for a 97 Chevy Suburban has been
discontinued.  Therefore, no Chevy dealers have this part.  I'm hoping that
someone here can recommend a place where I can find this ...

I have a 1998 K1500 with about 150k miles on it.  It is making a loud
clunking noise when I turn to the right and will especially make a loud
noise if the sttering wheel is truned to the right and I hit some sort of
bump.  Could this be a CV joint?  I also read another article on ...

I have the Edelbrock power pkg. #3702 Edlbrock Cam and heads. I have to
run 89 OCT, because of being in Mexico. My question with the wire
disconnected, what should I set the timing at BTDC. I am reading 0,4,8.
I am guessing 4 degrees and see how it runs with this great gas we have

How much should I pay for this, and what does or should it cover?

My truck has 20K on it and the brake pads have plenty left, but the
brakes have been getting softer and softer, so I finally took
everything apart only to find that on a 3 year old truck the rotors had
rotted and rusted out it the web area, anyone else have this problem?

Wipers squeaked.
Pulled off the black plastic cover at the base of the windshield.
Found the motor was driving the arms through two little ball joints that the
driver/connecting rods were attached to.

The window motor on the driver's side quit working. Does anyone know how to
change it out? How would you replace the motor after taking it out? It is
held in buy a type of rivet and it looks like you have to take out the
window mechanism just to get out the motor rivets. Any help ...

The steering wheel on this truck is loose. I can disassemble the column
down to the switch. I cannot go further as I do not see a way to remove the  
wiring harness. Does anyone know how to get the wiring harness out?
tia

I have a 2000 Chevy 1500 4X4 front end collision. Frame rail end caps are
collapsed; I know the procedure for replacement. There is a slight kink
behind the suspension cross member right side from side sway. I have been
told center sections of these frames should not be repaired. Is ...

I have a '93 C1500 with 204K miles that is in excellent condition.
Yesterday I ran the AC on high for about 35 minutes while driving home from
work.  About 20 minutes later I got in the truck and the fan would not come
on but the AC compressor was engaged.  I drove to the gas ...

Why would only high speed work on my wipers on 1999 Chevy Silverado?

I have an 87 3/4 ton 4x4 with a 350 and fuel injection, standard
ignition (no HEI).  I'd like to tune it up but, apparently, I need an
engine analyzer to assist in setting the dwell.  I do have one that was
my Dad's but, I have no idea how to use it.