Just had local machine shop press on three new U-joints and a new
carrier bearing on this 2 driveshaft system.  After re-installing the
driveshafts, I took a test drive, and after about 2 miles the carrier
bearing began to squeak with the rotation of the driveshaft.  I

I have a '04 S10. I accidentally drove about 50-60 miles with the 4X4
left on. It was freeway driving 65 and under. The curves weren't such
that I noticed any difficulty steering. I noticed when I glanced at the
light.

I've heard these often leak so I bought a new one.  It pulling the TB
to get the old gasket off and the new one on a snap on these engines?

I have a '97 blazer that is getting very bad mileage.  I am getting about
12-15 mpg.  It did through an O2 code so I replaced both sensors and
cleared the code.  That did not fix the issue.  I do notice that it feels
like the front hubs are lokced up even when I put it in 2wd.  When

is there any way I can find out if my Chevy S-10 pickup has the ZR2 package?
it doesn't seem to say it anywhere on the car or on the documentation i have
with it. but i do have the Wider bed that covers the bigger sized tires that
have come with truck.

What gives!! What happened to the old brass petcock? What the hell is that
plactic plug
with two flunky curved slots on the side of it. Why are they doing
this....How do you get the pllug out?

I just bought a 1997 chevy suburban 4X4 with a 350 vortec and 115,000
miles on it. Just what can I expect to go wroung with body
,frame,electric, you know all those little thing that seem to go wroung
with chevys,

Hi..first time posting in this newsgroup.
First off, I apologize in advance if this is not an appropriate
newsgroup for my questions but there does not seem to be a Chevy
full-size van or motorhome newsgroup in existence.

Hey Guys,
The spring loaded round plastic cover on my factory trailer hitch connector
is crumbling (02 Silverado). I don't think it stood up the sun and elements
too well. The friendly folks at GM are willing to sell me a whole new

I have a question for the group.  I am not sure if my alt is starting to
go.  It is producing 13.6 volts at full load and 14.1 with no load; it has
been doing this for a few months.  Since the 13.6 is not in that magical
range of 13.8 to 14.2 that we were told to look for, do ...

A year ago I had problems with my truck stalling while stopping so I
replaced the fuel pump. the problem was actually the ecm. Now its stalling
at start up it gets a shot of fuel then quits, this will happen every time
I turn the ignition to the off position then try again until the ...

I got the yellow light on 2 days ago out of the blue. The truck suddenly
will not idle or stay running without my foot on the gas.  The code reader
from the local parts store said 22 (TPS) and 33 (MAP).  I replaced them for
about $100. The light remains and so do the problems. The ...

It ran fine,parked it for two hours,wont start.
No spark so new cap and rotor, new coil, new engition modulator.
still no spark
its getting  power from battery to the dist. but no spark. help.

Does anyone know where I could find an after market AC for a '74 4x4
C10?  When I rebuilt this truck (used to be my dad's) all of the AC
components were unusable due to the length of time the truck just sat in
Leesburg, FL (plus...I didn't have the funds either then!)  :)

 This has been covered before,but I don`t remember the details.
I have a '04 GMC 2500 HD 6.0
Do I have a cabin filter? If so,where is it located,and how many
miles,or time before it should be replaced?