I got a problem with my AC.
First off, I only have high and low speeds for my fan.  I all ready put
in a new switch and it worked in all the speeds for a couple months and
then right back to only high and low.  The guy at the dealers parts

When towing a fifth wheel or carrying a camper my Silverado seems to be
overheating the tranny, even though these loads are well within the rated
capacity of this truck.  The tranny temp gauge shows about 190F when the fan
starts to engage   I understand there is some kind of ...

Hi, 91 Chevy Blazer S-10
Starter needs replacement.
I have never seen such a pain in the a**.
Woa!  I had to take off part of the undercarriage cross-member and I still

I am trying to replace the calipers and brake pads on the front of a
'93 Tracker.  I've had a heck of time because of rust, but I managed to
get through most of the problems without too much difficulty.  Until
now, that is.  One of the slider pins is thoroughly stuck.  I cut the

I want to add fog/driving lights to my 1996 Blazer LS.  I have the
Mitchell's wiring diagrams.  Are the wiring harnesses installed for
accessories not original to the vehicle?
I have tried to find the wires in the front , (removed grill) and behind the

Anyone know where I can pick up the whole package (BLACK)Bumper, Ends,
Brackets, and step pad in good-mint condition?  Please don't tell me a
dealer, I don't want to pay $4000!  At most everything should be around
$300.  I've checked Car-part.com, but I don't like the fact that your

I have owned many cars and SUV's in the past, but this is my first
pickup. It's a 1999 GMC Sierra 1500 SLE with the 5.3, i love this thing,
it has 66000mi. The previous owner took very good care of it, i have all
the service records.

Asked my dealer if they can connect to the back of the factory CD
player, maybe the cd changer input, and he said no. Apparently, the CD
changer input will get confused with ipod input. So now, only solution
appears to be one of those silly FM modulator deals. Any other

Looking for opinions on this one, Turn on the blower motor the amp gauge
drops, turn it all the way on high the amp gauge drops to about 9 volts,,
but the motor sounds good and works in all speeds...????Tks in advance for
any opinions. 94 GMC 1/2 ton  4x4 350

Hey everyone!
I've got a 95 Blazer with the Vortec engine 4.3 and when I go to start it,
it takes a little bit a cranking, about 5 seconds then its like it has to
wind up to get to smooth idle, and even then it could be better.  Upon

Quick backround of this closing saga;  Motor swap with reman motor.  Broke
old distributor, replaced with reman dizzy.
OK, now with the new distributor in place, I get surging in gear at idle.
What did I do wrong? (besides take the job?)  I read that the timing cannot

I went to Pep Boys to have the u-joints in my 2000 S-10 ZR2 replaced.
It was becoming a more immediate need and I was considering selling
the truck anyway.  The tech put the truck on the lift for his own
diagnosis after a trip around the parking lot and found NOTHING wrong

Anyone know where the washer fluid pump is located?  I tried mine tonight and nothing.  Not even the
whirring sound to show it's working.
I looked in a repair manual but there's nothign on it
-----------------------------------------------------

     The tailgate lock on my 1993 S-15 Jimmy is broken.  A key fits in
the lock.  It normally is twisted CCW to release the glass, and is
twisted CW to release the tailgate.  The entire lock core is gone, as
if it was drilled out.  The remaining portion of the cylinder is still

I am the proud owner of a 2005 K2500HD Crew Long bed Duramax.  Now the
question is weather to have it rustproofed.
There is fairly heavy salt use in this area of Central NY.
My '91 K2500HD was not rustproofed.  I had the cab corners replaced a