| Thread | Last Post | Replies |
|
| Safari 98 Radio Backlight bulbs | 19 Aug 2005 13:31 GMT | 4 |
I read few topics here about desperate attempts to fix backlighting on Delco radios. I have same problem. Only two light bulbs on left side are lit. all of the rest of them are blown. THese are usual 12 v light bulbs with
|
| Bed liner | 19 Aug 2005 12:59 GMT | 14 |
Any thoughts on bed liners? Like linex ,rhino, or Herculiner do it your self? I did some reading on the Herculiner and is seems if you give it a few extra coats(like 4) its ok. But Im not sure how it would do with UV rays.
|
| 98 Tahoe -- "Shudders under load" | 19 Aug 2005 06:20 GMT | 4 |
I have a 98 Tahoe, 2WD, automatic transmission, 145,000 miles. I live in the hill country west of Austin, Texas. When I am going up some of the steeper inclines, the truck does not downshift from overdrive, and it begins to shake and jerk. I used to be
|
| Chevy/GMC man buying first Ford (Ranger) | 19 Aug 2005 06:00 GMT | 8 |
This will be my first (and likely last) Ford. But it's an excellent deal, and I kinda like the older Ranger. It's a '84 4X4 V6, so no extensive/expensive 'puters, 4X4 electronics, etc... plus it will get around 26 to 28 mpg.
|
| Rear Disc Conversion Kits for 98 K2500 GMC Suburban | 19 Aug 2005 03:52 GMT | 7 |
I want to convert the drum brakes on my GMC Suburban to disc brakes. Are there any conversion kits? Thanks.
|
| Starter?? Blazer 94 4.3 W 4x4 | 19 Aug 2005 00:32 GMT | 12 |
Lately I've been noticing a problem.(weather has just turned a little colder) If the car sits overnight, you put the key in and hold it for 5 seconds it just turns over and over but doesn't start. Just sounds like it's spiinning. Can do this again and it spins and spins doesn't
|
| 2001 f-350 7.3 power stroke | 18 Aug 2005 23:52 GMT | 4 |
i have an 01 powerstroke deisel that dies when you stop or when ever it wants has a code p1280 ipc sensor looking for an info possible thanks much
|
| AC Clutch! | 18 Aug 2005 23:37 GMT | 3 |
I have a 96 s10 4.3 4x4. The clutch is making bearing noises, I do not know how involved it is to replace the bearings. Also is there anyway to remove the clutch without depressurizing the system? And damn Chevy for making the belt routing with out AC with an extra pulley that ...
|
| and again I ask for help | 18 Aug 2005 11:59 GMT | 13 |
I still have a question, ok I've got a 99 GMC Jimmy with the Auto4x4 system, my TCCM took a crap in january for some reason, can I manually switch the transfer into 4hi without the TCCM?
|
| improving mileage | 18 Aug 2005 09:36 GMT | 9 |
Hey guys, Recently our gas prices have been on the rise. We are now paying a whopping $1.129 Canadian for a liter of gas I think I got the conversions right:
|
| 92 chev rough idle at start | 18 Aug 2005 08:05 GMT | 5 |
My 92 chev 1500 5.7 has a rough idle at start for about 10-20 sec then it kicks back up to normal idle runs fine till shut off then does same thing over again. i have replaced EGR and IAC. Any suggestions would be greatly appreciated
|
| WARNING - Powers Chevrolet- Mesa, AZ | 18 Aug 2005 07:44 GMT | 6 |
Warning to everybody that is shopping for a car... especially a Chevrolet! This has got to be the WORST Chevrolet Dealership in the United States! Powers Chevrolet out by the Superstition Mall in Mesa, Arizona have a Service Manager named Derek Hadid that seems to be totally focused ...
|
| 02 Silverado 4x4: Improving the ride and handling | 18 Aug 2005 02:15 GMT | 2 |
I am not complaining about my present set up. Just wondered if there is any way to improve the ride and handling of my 02 Silverado 4x4 that has all the stock basics. I got some pretty significant improvement just by changing the factory tires
|
| 96 chevy blazer transmission | 18 Aug 2005 01:32 GMT | 2 |
there was never any sign or any reason to believe my tranny was going bad. i was driving it and it suddenly stopped moving as if in "N". no matter what gear i put it in, it will not go. except when i first start it and it will go into gear "R" or "D" but only for about 20 seconds, ...
|
| EVO | 18 Aug 2005 00:35 GMT | 2 |
What is the easiest way,(besides having someone else do it),to repace the evo sensor on the steering column of my '97 GMC Sierra XLT K1500? Does the complete steering column have to be removed?Thanks,Ed
|