Anyone know how to get car wax of black plastic? I tried back in black.
It seems to cover up about 75%. But it is still there.

My 97 Z71 (350 vortec) truck takes about 5 seconds to start. I was told
this could be the fuel pressure regulator. It is a silver cannister a
little over an inch round and tall. Am I on the right track and where is
this located?

about six months back, i replaced the pads and rotors on my 96 half ton
express van.  At the time, I was lazy and didn't check the backs.  i've
been putting it off.  last friday, my wife reported a metal grinding
noise.  i assumed i had waited too long on the backs and stopped by ...

I have a older carb chevy V/8, I understand there is a closed loop
system and a open when it comes to what valve covers to use. I
currently have the valve covers that have the large breather that vents
to the air cleaner and also a PCV Valve. I seem to be using a large

       I have a 99 gmc yukon and sometimes the service 4wd light comes on,
when it's on the 4wd buttons dont light up and nothing happens when I push
them. If the service light doesnt come on when I start my truck, then the
buttons work and the 4wd does turns on when I push the ...

I am new to this group. As a matter of fact I just got my first ever
pickup(I'm 37) A '95 two wheel drive ,4-cylinder S-10. The truck was bought
new by my father-in-law and has 51K miles on it. He drove it pretty steady
for about 5 years and then his health went downhill. He is ...

The 1995 Blazer s10 I recently purchased (4.3 V6, 4WD, auto) has a sheared pinion gear.
I'm guessing it would be cheaper for me to just swap out a used rear end than have a
specialty shop set me up with a new gear and posi assembly.  What rear ends will
interchange with my '95?

Where is a good place to get a new tailgate for 2003 Silverado?

Anyone know how to program the lights to come on when you start the truck?
thanks, John

Hi all, one month ago i bought a 99 GMC Sierra 1500 5.3, after looking
it over i see that it has edelbrock shocks, they seem to be very soft,
when i go slow over a speed bump or back into my drive way, the front
end will bounce a couple of times.

How do you get the bolts out of the top of the transmission?

One of my driving lights has burned out.  I opened the hood to replace the
bulb and had to remove a cloth-like rubberized cover to access the bulb
fromt he rear.  However, I couldn't squeeze my hand into the hole properly
and couldn't grip the bulb housing with enough force to ...

My 97 Z71 always takes a few mins to start and in the winter time warm up. I
don't know about the pressure regulator.

I have an 1988 GMC Jimmy 2.8l and the water pump went out on it. I really
dont even recall ever having to replace the water pump in this. I was
worried about the removing the bolts but all them came out easy except for
one of the bigger bolts. A bolt next to it was a little ...

Any opinions on how good in may be?I know the saying is you pay for the
quality you get.The Super Tech at WalMart is about the cheapest on the
market.With fuel being so expensive and oil prices being on the rise.I
was wondering if someone on here has been useing it long enough long