| Thread | Last Post | Replies |
|
| 1991 Suburban 4wd, 350 | 30 Oct 2005 04:23 GMT | 2 |
Last week my transmission went wonky on me. It normally shifts at about 18mph, about 32mph, then again at around 50mph. Now on the upshift it misses the 18mph shift, shifts at around 32mph then again at around 50mph. It never gave any indication of trouble
|
| 1996-Present 454-7.4-8.1 Suburban Engine | 30 Oct 2005 01:31 GMT | 3 |
I looking for information on the differences in the fuel injection for the 1996-Present 454-7.4-8.1 Chevy Suburban. Mainly the throttle body. When did it change to the electronic throttle cable. Can anyone offer and help.
|
| 95 chevy tahoe reverse lights | 30 Oct 2005 00:43 GMT | 1 |
I have a 95 tahoe, and the reverse lights come on when I turn the head lights on. Any suggestions?
|
| How to remove anti siphon screen | 29 Oct 2005 20:04 GMT | 5 |
I have a 2002 Chev s-10 . Anyone know the easiest way to remove the gas tank anti-siphon device? When I needed gas out of it to run the generator after the hurricane, I couldn't get it. (the truck was full and I couldn't buy gas anywhere) I need it ready for the next hurricane.
|
| 05 Silverado vibration | 29 Oct 2005 19:36 GMT | 3 |
My new 05 Silverado 4X4 1500 has a vibration that appears at 43mph. It slowly dissipates until it is gone at around 55mph. The dealer has replaced two tires and checked the wheels. The dealer says the rims are good and that the "vibration" is now "normal." Any suggestions as to ...
|
| Recall Silverados | 29 Oct 2005 14:46 GMT | 13 |
If you want free work to your silverado, there was a recall on the emergency braking system. I think the years are 1997 - 2005. The emergency brake wears out and has to be replaced. Contact your dealership to get this fixed for free.
|
| One turn signal | 29 Oct 2005 08:24 GMT | 5 |
I have a 79 surburban and the rear right turn signal doesn't flash.I checked the bulb and put it in the left rear side and it worked. When i put on the flasher only the right rear doesn't flash. If the filiment which controls the running lights work why doesn't the turn
|
| 97 blazer will not start | 29 Oct 2005 01:20 GMT | 1 |
when the key is turned to the start position the engine cranks but will not start. there are no lights on dash cluster (batt,seatbelt ect.)and no voltage showing on gauge. also noticed that it can not be shifted out of park unless it is done manually. any ideas?
|
| chevy question | 28 Oct 2005 04:41 GMT | 4 |
I was wanting to know if i can bolt a 4.3 vortec into a 1984 chevy s10. It already has a 2.8 v6 in it now that blew, so i figure i can put another v6 into it but the vortec is bigger so i was wantin a real answer?
|
| Heater Issue..'95 Silverado | 28 Oct 2005 02:51 GMT | 1 |
1995 Chevy Silverado Z71 Extended Cab 4X4 5.0L Getting reduced airflow from all settings(defrost,floor,vents ect.) including AC.The longer it runs the less the airflow gets until there is hardly any at all.Button that switches between outside air and recirculating
|
| Fuel problem | 28 Oct 2005 02:24 GMT | 4 |
I have a 97 Chevy Z71 W/138000 miles My son drove it the other day and made a trip with no problem He came back out 3 hours later and the truck won't start I can't hear the fuel pump running. I replaced the fuel pump relay
|
| a voir | 28 Oct 2005 01:39 GMT | 2 |
 Signature Dédé http://www.club4x4lesmillesources.com http://www.monosport.malemort.info
|
| 03 Suburban airbag replacement. | 27 Oct 2005 23:13 GMT | 3 |
Hello all. i recently went to get in my vehical for work and my stering weel airbag and passenger side airbag were deployed? i have no idea how this happend since the car was sitting in the driveway?...is there anyway i can replace the nessesary parts for this? or do i need to ...
|
| 2001 silverado lt gas gauge | 27 Oct 2005 10:53 GMT | 3 |
Has anyone had this problem on (low on gas light) coming on and fuel indicator goes to E ,when you know the tank is fuel , im thinking that float sensor might be sticking??? any help on this would be appreciated. Thankyou,
|
| Bleeding Power Steering System 1996 Blazer | 27 Oct 2005 10:04 GMT | 3 |
How do I bleed the power steering system on a 1996 4.3L 4X4 Blazer? I've read some places that all I need to do is turn the wheels from side to side. Is this all there is to bleeding the system? TOM TAYLOR
|