Hey all
I've got an 1989 K5 with a 2 in lift on it.  Anyway, It pulls to the right
when you brake, the harder you brake, the worse it is.  We've replaced both
front hoses, calipers, had the rear  hoses blown out, new wheel cylinders,

http://cgi.ebay.com/ebaymotors/Chevrolet-C-10-NEW-1984-CHEVROLET-PICKUP-1-420-OR
IGINAL-MILES-CHEVY_W0QQcmdZViewItemQQcategoryZ39409QQitemZ4574959160QQrdZ1

My truck, a chevy 1987 S -10 V6 w/ fuel injection
the past few days has been giving me problems starting.
I put new plugs, wires, PCV valve about a month & 1/2 ago,.
recently the truck at times will turn over like there

My S-10 is ready for a new battery I think. Didn't drive it for a week
and now all I hear is the starter motor clicking when trying to start
it. Dont want to try and stretch its life any longer with the winter
approaching.

Can some one please fill me in on what is the problem with
dex-cool. I have read so many pros & cons? Would like the
real scoop
--

I have a 1995 s-10 pick up truck 4.3,... manual trasmission.and this is
the problem I'm having
I put new trans, new clutch, new pumps (master and slave) and when the
truck is cold, in the morning it works good, the way it should be, but

I have an 03 silverado, 4.8 V8( just got the 36, ooo mile service done
by the way) I drive in hot weather (100-115) very frequently, and
notice if I'm in traffic and with the a/c on very low ( dial 1-2) the
engine starts to heat up ,I know its kind of normal, but it heats up

I have a 1995 Blazer S10 (4.3, 4WD, auto) and the transmission suddenly
does NOTHING when in 2WD. No forward gears or reverse. When you shift
from park into a gear, there is no feeling of the transmission shifting
and the engine revs freely, as though you were still in park and the

I keep replacing a fuse. It controls the gas gage, temp. gage, low fuel
light, battery low light, shift light.  Any ideas how to track this?
Thanks

Hey all
I've got an 1989 K5 with a 2 in lift on it.  Anyway, It pulls to the right
when you brake, the harder you brake, the worse it is.  We've replaced both
front hoses, calipers, had the rear  hoses blown out, new wheel cylinders,

I recently lost my #2 remote for my 2004 Chevy 2500HD and will be purchasing
a replacement on eBay soon. I still have my #1 remote.  My question is can I
program the new remote myself without any special (expensive) tools or do I
need to go to the dealer to have it done?

S-10 Pick-up truck construction cap fits long box
best offer or trade for regular cap
call 613-347-3525

I'm looking for a set of Alcoa aluminum wheels for 2001 GMC dually.
Jim

I am getting a humm in 4hi and it gets a little throatier in 4lo.  I was
wondering if I might have a bearing starting to tank.  Has anyone noticed
this?  I am running full synthetic throughout the system.
Thanks,

How do I replace the ignition switch on my 1984 Chevy Scottsdale pickup?