I need help figuring out what this sound would be from. I have a 2003
Silverado 1500 4x4.
I get this high pitch whine from the front left side of the truck. It
does not matter if I am turning, braking or just moving. It does not

Yesterday, a man tried to abduct my housekeeper and four-year-old daughter.
My  housekeeper described the car as a  small white pickup truck with either
either an extended cab or a second row of seats with a second set of doors.
She is certain that there was a second, smaller ...

Just a thought...can you replace regular headlights in a 1998 Blazer with
the new halogen lamps?
I have a hard time seeing in the dark and these are really clear lights that
helps me to see better...I

My 98 Blazer has AM/FM/CD/Cassette (the cassette is a separate module
mounted by the front of the floor console). What are the chances of there
being a set of AUX inputs on the back of it?
How tough is it getting into the radio guts, access reasonable or a beast?

spark plug vibrates loose, can't really tighten

I have a Trouble Code P0304 "Cylinder 4 Misfire Detected" on my 1998 S-10
Pickup, 2.2L. The motor will idle real rough and has little power. This
problem is intermittent and I cannot seem to determine what the cause is. I
have replaced both coil packs and spark plugs, but it ...

I  have a 98 V8 454 Chevy truck and the check engine light is on. I got a
code reader. It shows a code PO171, system too lean , bank 1.
Does anyone I any ideas what it could be?
Thank you for your help,

1974 Chevrolet K-10    has Electronic distributor   350 engine.
We have replaced everything inside there, cap plugs,coil.,Rotor etc.
,
The thing wont send fire about 1/3 of the time.

67,000 miles on vehicle.  Runs fine until you are pulling a load.
Truck seems to miss and loses power, especially when pulling a grade.
Sparks plugs appear okay and fuel filter has been changed.  Any
suggestions on what the problem may be?

Anyone know if the basic frame on a 1984 C10 2WD SB  will swap to a 1986 K10
4WD SB? I found a 86 truck with a broken/rotted frame and have a good frame.
I realize I need to swap out the front end and cross members, but need to
know if the side rails are the same. Both trucks are V8 ...

Tranny or perhaps transfer case is leaking. On the driver's side, there
appears to be a steel hemispherical cover (Looks like a school teacher's
bell, without the button) that has rusted and is leaking. Can this be
repaired? If so, where to get part??

I am in dire need of a replacement dip tube for a 4.3l V6 in a S10
Blazer.  Does any one know where I can find one?  I cannot find any
reference online that leads to that  part.

My truck,  a chevy 1987 S -10 V6 w/ fuel injection
the past few days has been  giving me problems starting.
I put new plugs, wires, PCV valve about a month & 1/2 ago,.
recently the truck at times will turn  over like there

Have an 89 full size blazer w/350 & 7R4 tranny and need some wiring help.
The dash has been busted up and the throttle body has been replace with a
Edelbrock 600. What would it take to power up the ignition (HEI) and voltage
regulator.

I  have a 98 V8 454 Chevy truck and the check engine light is on. I got a
code reader. It shows a code PO171, system too lean , bank 1.
Does anyone I any ideas what it could be?
Thank you for your help,