I have a 1995 Chev. S-10 pickup and I cannot get my turn blinkers to work.  I
have replaced all of my bulbs but the turn signals do not work. Can someone
please give me some advice on how to solve the problem. Thanks in advance for
your help.

All,
Looking for anyone currently working with PTK TTCN-3.
In particular our project wants to use these tools to generate test scripts
based on some Tau G2 models as input.

Well I finally got a cam and lifters ordered for my truck. Cam #
12366543 from a crate 502. My question is will this work with the stock
454 in my truck? Truck spec.'s are as follows
1996 GMC 2500HD with a Gen VI Vortec 7.4L (454), Automatic, 2wd.

My new 05 Silverado 4X4 1500 has a vibration that appears at 43mph. It
slowly dissipates until it is gone at around 55mph. The dealer has replaced
two tires and checked the wheels. The dealer says the rims are good and that
the "vibration" is now "normal." Any suggestions as to ...

I am looking for the fuse for the auxiliary outlets and the cigarette
lighter in my suburban.
The handbook mentions an under the hood fuse box with 24 spaces for fuses
and gives a good description of the fuses, the problem is in my truck there

I have a '96 Blazer that I use to pull boats and utility trailers.  I just
acquired a trailer that has electric brakes and want to hook therm up.
My current wiring connector is the standard flat 4 prong.  The new trailer
has a round 6 prong connector.  When I initially spliced in ...

got recall notice saying Chevy will replace fuel filter on my 2003 2500HD duramax
anyone know what problems were caused by the bad filter.  My truck stalled out on me in August and the dealer said the injectors had to be replaced (under Warranty)  but they also stuck me for a non ...

This is the second time for this post as the response was really low.
I am getting a humm in 4hi and it gets a little throatier in 4lo.  I was
wondering if I might have a bearing starting to tank.  Has anyone noticed
this?  I am running full synthetic throughout the system.

Can the 97 blazer be programed by me or do I have to go the the dealer?

runs rough,drives fine until hot, if I stop at a red light, then proceed
will start to buck and seems to lose power,when bucking stops drives fine
also after stopping for about 15mins. cranks but will not start for about
an hour then starts fine but still runs rough. I did a tune

"GMC Sierra offered as a hybrid"
http://www.washtimes.com/autoweekend/20051103-083621-8663r.htm

Has anyone had the same problem I have?
If you stop, put it in reverse (before you can count to 3!) and press on
the gas. It runs like one cylinder is dead for a few seconds!
Thanks

I was wondering if I could run E85 in my 99 Jimmy 4.3 v6

Hey guys,
Anyone have a source for OEM injectors (TBI), and the Fuel pressure diaphram?
TIA

I just had my 2004 2500HD into the local Chevy dealer for a free oil change
they were giving away for Chevy Owners Appreciation days.  I have had the
truck for 20 months and it has 17000 miles on it.  Everything was fine
except for the engine coolant.  The repair guys said they ...