| Thread | Last Post | Replies |
|
| Distributor gear woes? Maybe??? | 13 Dec 2005 12:52 GMT | 14 |
Well I finally got the cam, Lifters, Timing set and new distributor gear in my truck. Now it runs but something is not right. The truck is a 96 GMC with a 7.4L Gen VI motor. (454) Cam I installed is from a ZZ502. It runs like a bear but starts hard (Like timing is off) and
|
| S-10 Problems | 13 Dec 2005 10:26 GMT | 1 |
Have 99 S-10 2wd. Have trouble getting it started turns over but wont start have to turn key severeal times in order to get it started. Once on runs smooth. Didnt use for 3 days now doesnt want to start. Changed fuel pump and fuel filter.
|
| FIPK and Throttle Body Spacer | 13 Dec 2005 10:00 GMT | 2 |
I have a 1994 Silverado with a 5.7 and was wondering if it is possible to have both a K&N FIPK system which i already have and also a throttle body spacer. I didnt know if they would both fit underneath the hood or not. Also curious as to wether the throttle body spacer is even ...
|
| 1988 Chev S10 blazer 4.3 2-WD | 13 Dec 2005 09:54 GMT | 1 |
Help......my blazer will run fine for a few minutes then shuts down once it warms up alittle and will not start till it cools down again......not running hot, according to temp gauge, checked fuel pump, filter, replaced coil, dist cap and rotor but continues to put me down. Any ...
|
| Its getting cold and I got no heat! | 13 Dec 2005 09:48 GMT | 3 |
Ive got a 2002 S10 4cyl 2WD that has absolutley no heat. Ive tried replacing the thermostat but no luck. Anyone know what else to look for/check other than the heater core? I really dont want to tear apart my dash or fool around near the airbags.
|
| Truck tailgate on Blazer? | 13 Dec 2005 05:08 GMT | 3 |
Hey all... I've located a company that *did* make half-cab conversion parts for Blazers. These pieces bolt on to add a rear window behind the driver and block off the tailgate. I've contacted them and am awaiting a
|
| HELP 85 Blazer!!! | 12 Dec 2005 23:11 GMT | 9 |
I have a 85 K5 Blazer ,Runs great until I get on the highway, No top end power slows down going up hills,(tractor trailers pass me) Hard starting in the morning choke problem? After it gets warm runs good till hills. Does this sound like the carb?? Motor is a 305ci, Thanks for ...
|
| Parting Out!!! | 12 Dec 2005 23:10 GMT | 2 |
PARTING OUT!!! EVERYTHING MUST GO!!! 1988 K10 Suburban - Body rough, no engine/trans/transfer case, no buckets/center console. 3.73 axles in GOOD condition, good springs, power windows/locks, deep tint windows, cargo doors, rear heat, A/C, grey
|
| show headlight adjustment 04 silverado | 12 Dec 2005 01:34 GMT | 2 |
can anyone describe headlight adj. 04 chev silverado?
|
| water leak in cowl of 95 GMC?? | 12 Dec 2005 00:33 GMT | 5 |
My 95 GMC Sierra (3/4 ton) has an annoying leak following a rain or snow fall. There will be a small amount of water that will leave a small trail on the right floor mat toward the door jam. Last year in the winter it filled with water (blower housing) and froze, then when I
|
| SPEED SENSER QUESTION? | 11 Dec 2005 18:40 GMT | 1 |
i have a 99 dodge ram with a v10 motor. my question is. i disconected two plugs on the drivers side under the hood right by the brake fluid resivor. dont ask why. long story. anyway i found out on of them disconneted my speedometer. i thought wow kewl i can drive it with out
|
| Meyer plow question? | 11 Dec 2005 14:17 GMT | 5 |
I have an '88 chevy 2500 4x4 standard cab, and a Meyer angle plow setup for an '87 and older chevy. The plow is the standard/conventional non EZ mount style, my question is- Will this plow fit on this truck? I know the EZ mount style fits '88-2000 chevy and GMC's. I was wondering
|
| Rear wiper S-10 Blazer | 11 Dec 2005 06:08 GMT | 1 |
My tail gate glass wiper only moves off park about 5 inches and stops any help would be appreciated, its been used very little.
|
| S-10 Blazer - antifreeze loss - white smoke on startup | 11 Dec 2005 04:29 GMT | 4 |
I'm losing a bit of antifreeze every trip, but don't see it leaking or spraying, not getting in the oil. Is it more likely the intake manifold gasket or a head gasket?
|
| 4x4 problem 01 silverado 1500 series | 11 Dec 2005 04:24 GMT | 2 |
When I engage the 4 wheel drive on my 01 4x4 1500 Silverado the light blinks but it will not engage in hi or low range. How do you troubleshoot it. In the two wheel mode the light stays solid Thank for you help in advance or any ideas
|