| Thread | Last Post | Replies |
|
| 91 blazer 4wd | 19 Jan 2006 12:08 GMT | 6 |
Hi, my son has a fuel injected blazer, it won't start, they poured gas in the carb it stayed running until i burned it out, people tell him it could be fuel pump which is in gas tank or the fuse, but noone knows where the fuse is to check it, could anyone tell me if it does in fact
|
| Water leak from Sunroof /03 suburban | 19 Jan 2006 10:21 GMT | 2 |
I recentlty purchased a 2003 Suburban. After a heavy rainfall a few days ago some water dripped down from the interior light just behind the sunroof. My wife also described a water "swishing"sound in the head liner. After some googling I found some reports that there is some ...
|
| Skips when Driving | 19 Jan 2006 06:27 GMT | 4 |
I have a 1991 Chevy s10 Blazer 6cyl. When I'm driving and I reach about 65mph, the trucks sputters like it is skipping. I've already checked the spark pllud and wires, What else could it be?
|
| 1988 GRAND AM | 19 Jan 2006 05:42 GMT | 5 |
I HAVE A 88 GRAND AM THAT THE HEATER DON'T BLOW HOT AIR.THE AIR ALSO JUST COMES OUT THE AIR VENTS NOT THE FLOOR OR DEFROST LOCATION.
|
| 2 S10 questions | 19 Jan 2006 02:53 GMT | 3 |
1991 S10, small V6, 5spd, AC 1) Occaisionally the *Service Engine Soon* light comes on and stays on for maybe 5 mins and then goes off. This truck is routinely serviced and when the light comes on all the gauges
|
| 2000 Suburban cabin air filter | 19 Jan 2006 01:01 GMT | 2 |
I am about to change the cabin air filter in my 2000 Suburban for the very first time. - Is there 1 or 2 filters? - Any advice before I start?
|
| 1992 Silverado shakes at about 45mph | 18 Jan 2006 23:46 GMT | 4 |
We have a 92 Silverado that shakes or shimmy's at about 45mph when accelerating. What might cause this?? I don't want to start just replacing stuff. I'll probably take it by the shop and have the tires rotated and balanced, but I
|
| 4 Wheel Drive won't engage | 18 Jan 2006 21:55 GMT | 1 |
95 Chevy T-10 (called S-10 by most) Blazer. Manual shift 4X4. Transfer case will not engae into four wheel HI or Low. Any ideas on what to do. Is there a sensor for this? Need the 4X4 for the snow.
|
| Wheelin in an 87-91 full size Blazer | 18 Jan 2006 00:07 GMT | 3 |
Anyone do any serious wheelin in a full size blazer? I am contemplating getting either a Jeep TJ for serious offroading or an 87-91 full size Blazer with the front axle. I don't want to kick the crap out of my 98 Z71 anymore.
|
| 96 Express with strange problem | 17 Jan 2006 23:25 GMT | 4 |
Boy I've got a wierd one for you guys. I've got a 96 Express Van (G1500) with a 305 V8 and 130K Miles. I first noticed this problem when cruising at 60 on the highway (on cruise control). I topped a very slight incline into a slight downhill segment of the road. As the cruise ...
|
| Advice Requested.after intake repair | 17 Jan 2006 21:47 GMT | 9 |
Just had my favorite mechanic change the intake gasket on my 91 suburban (350). Specifically asked him not to use a scotchbrite pad to clean the heads but he did anyway. I am concerned that there may be debris in the oil. I have heard of stories of these pads leaving ...
|
| 98 gmc 1500 350 4x4 | 17 Jan 2006 17:03 GMT | 2 |
Used to get 18-20 mpg on the highway, replaced catalytic converters, plugs, plug wires, dist cap, rotor, oxy sensors, fuel filter. now the best I get is 16. get occasional misfire on #7-could it be evaporative emission control charcoal filter? open to any ideas. have 111,000 ...
|
| 98 'Burb: Cruise Control References What? | 17 Jan 2006 14:17 GMT | 3 |
Anybody know what cruise control uses to tell whether to apply more or less power? I'm thinking about long drives on straight, snow-covered roads. In the past, I've gotten into minor trouble a couple hours into a drive doing,
|
| tranny fluid question | 17 Jan 2006 00:52 GMT | 2 |
Is it safe to say that if you do not see any fluid leaking out of the tranny and it is low then it was never full in the first place? It has no way to get into the engine to be burned off has it?? This is on a 2002 S10 38000 miles bought
|
| 1988 s10 wont start? | 16 Jan 2006 20:35 GMT | 11 |
Just bought a 88 s10 with the 2.5 4cylinder. It was running a little rough so I decide to do a tuneup. I did the plugs and wires and drove it and it was better then I decided to do the cap and rotor. Now I cant get it to start. Anyone know the firing order and is it from front ...
|