I am puting a 305 in my 89 K5 Blazer and need the wiring for a 305 as
the old wiring wase junk can any one help me out ?????

I assume that allot of us are fans of the Spike tv show Trucks! that airs on
Saturday afternoons. One of the main
reasons I watch the show is because of the great host, Stacy David. The bad
news is that he is leaving the show,

I have a 1996 Chevrolet 1 ton with a 454 that has 101K on it.
It is hard to start some times, in that it turns over repeatedly, but
does not start. After severl tries it does start. This is not a
constant problem, although it happens at  differnt times.

I currently have a wheel that no longer has the air bag assembly which
leaves a pretty nasty looking empty space in the center of the wheel.  I'd
prefer to not replace the bag assembly for reasons dealing with a small
statured driver.  Are there any differences between the ...

Well I'm running out of ideas. Found a blown fuse was causing my MAF
DTC code to come up. Replaced the fuse. Pulled out of the driveway.
"POP". This has been continual with every experiment I've tried. So far
I've rotatedly unplugged everything on that line. Even to the poing of

I am getting code #43 under hard acceleration.
There is knock or rattle first then the light comes on.
Does it sound like the knock sensor?
I just put a small fortune into the truck so I want it to run right but I

Sorry I know this is a cross post, but I REALLY need some advice (time
sensitive).  I won't make this a habbit, I promise...
Hello All,
I have a 1999 K1500 Suburban, That I am having fuel pressure issues

 04'2500 HD.
Had the Intermediate steering shaft replaced July '05.Now I`m having the
same symptoms.
Anyone else had to do this more than 1 time?

How hard/easy is it to come across the frame and running gear, 4 speed
trans, NP205 transfer case,front and  rear end, of a 1980 3/4 ton or a 1 ton
( motor optional ) ? Thanks in advance!

I'm having a bit of trouble with my little 1987 S-10.  The idle speed
it too high.  First I thought it was the darn injectors which were
spitting fuel so I replaced those and cleaned out the injector
assembly, replaced the gaskets and put it back together.  Same thing

The motor still doesn't run good.We have put another head on one side,the
other was cracked but had it fixed.The truck still runs rough if you don't
unplug the fuel sensor.Has a light blue smoke comeing out pretty good.Still
losing water somewhere.Has blowby out of the pdr valve and ...

I am having a problem starting my 92 Blazer.I have replaced fuel pump,fuel
filter,plugs,wires,dist. cap,& rotor. I have also taken intake manifold
off and cleaned out everything. It had been sitting for about 6 months
before I repaced everything. When I git in to start it and turn ...

2004 Z71  5300 engine.  13 to 15 MPG on 2 lane highways 90+ mile runs
What is the chance that a K & N air filter will short out a mass air sensor?
Installed a K&N air filter in an attempt to increase mileage (no difference)
and two weeks later took it to the second dealer for poor ...

Hey guys.  My '97 S-10 has started having problems with the turn
signals lately.  Whenever I use the turn signals (either side), I get
an irregular flashing pattern.  Usually too fast, but sometimes the
light just stays on.  Any ideas on what might cause this and what I can

i've noticed that the left side of my truck (04 silverado) sits lower
in comparison to the right side...
it is always equal weight in the truck at all times...
does this possibly have something to do with bad shocks/springs??