I noticed that my right front shock(OEM, 106k miles) is coated with some
kind of light oil, looks like it might be hydraulic fluid.  If the shock is
in fact blown out, how hard is it to change out on the front end?
Thanks In Advance,

I have an 06 silverado with a stainless steel exhaust and I wanted to
polish the tailpipe.  Is there any good links with step by step
instructions, or does anyone have any ideas?

I am wondering if the wind deflectors that fit into the window tracks
actually work. Do they really cut down the window noise.
They don't use tape or glue but they must have a bracket or some
fastening device.  Is that detrimental to the appearance of the truck.

I have been trying to narrow down the cause of the vibration this truck
experiences from 57 mph to 65 and then again at 70 mph. Is it possible that
being out of alignment could contribute to this? I have already replaced all
the u-joints and tires. The steering wheel is off center ...

According to the LMC truck catalog. The Vin of my truck says its a 3/4 ton
Code 2, with a 350 heavy duty engine,  Code M. The GVW range is G which
isn't listed in the catalog, But F is the highest weight listed at 7001-8000
lbs. So what is G. But here's whats got me now. When I ...

I have the 6L with a rattle in the steering column every time I turn or hit
bumps.  Someone said that it was the intermediate steering shaft.  Has
anyone else had this problem?

i have a 90 blazer with a 400 small block out of a 74 impala , anyone
wouldnt happen to know what the marks are when doing the chain and what
should the timing be set at? also is # 1 on the drivers or passanger side.
and while were at it i could use the firing order

 A while back,someone posted a message about the oil from the air
filter was shorting out the mass air meter.
A friend of mine just put the K&N air intake setup on his '02 6.0
I was telling him about this,but can`t find the past posts.

anyone know of a conversion for a 03 to 06 silverado 1500 truck? The only one i can find is insanely expensive
TNK
--
zacrag

I have a 1999 Chevrolet Suburban K2500. Several of the lug nut caps are missing,
and I would like to buy some to replace the lost ones.
Do you know of a good online source for these?
Or should I just go to the dealer and get them?

---refresher---
1987 Chevy G20 Conversion Van
   -Hard starting without a touch of throttle
   -Low idle when started cold

The black plastic bumper cap on front bumper of my 02 Silverado is
cracked and I would like to replace it.  Are there any special
procedures/techniques involved in the replacement?  Do any fasteners
need to be replaced, or can they be reused?

Our extended warranty company 1SourceAutoWarrantee (reinsurer is Primeguard)
went insolvent. We are looking for members for a class action suit and to
discuss ways of trying to recoup our losses. I started a Yahoo group. If you
can help or have been burned, post to ...

I asked this in alt.4x4.chevy.trucks, but did not get much of an answer, so I
thought I would ask it over here.
I just purchased a GMC Sierra C1500HD Crew Cab. I am looking to raise the front
end 2-3", to level it off to the rear. As is sits now, the front does not sit

Hello i'am having a problem with  my 4.8 it is having a hard time starting
unless you press on  the gas alittle bit The fuel presures 51 to 56 can
any one help.