i have a 1991 chevy silverado and it sat outside all winter and this
spring i charged the batery and tried to start it. It started it ran
for about 30seconds and then it stalled and the check engine light
turned on. So I was checking under the hood to see the fluid levels and

when my boyfriend got this car it already had many problems. we moved down
to miami and now the car is starting with a whole new set of problems..
when i tried cranckin up the truck the other day it made a few click
sounds .so i tried it again and nothing happen no clicking or ...

 Truck is a 1990 Chevy k1500, 160k miles. I'm getting battery voltage
to the grey wire on the fuel pump harness, but no fuel pressure/pump
activity. I'm getting ready to drop the tank and check/or replace the
fuel pump unit, but am wondering if it'd be easier to get a few ...

one of my two  door remotes stoped working the other day, i replaced
the battery and still nothing,do i need to reprogram it? if so how?

Just wondering what every body thinks of syntheic motor oils, my dad swears
by Castrol SynTec oil, what are the pros and cons of it and switching to it
on high milage engines, 03 envoy with 117 K miles.
He claims it inproves milage and makes it run smoother, is the extra cost

On the way home from having my front brake rotors and pads done, The truck
( 89 k5 ) seemed to lack power. Soon the RPMs told me the trans was not
right. There can't possibly be any correlation between the two, unless they
trashed it on a test drive. I was 10 miles from the shop ...

I have a 99 chevy suburban 5.7 fuel injection 77,000 miles, what is the
best way that I can clean the whole fuel induction system, or what part of
it I should clean? Tank you.

Truck will not start we thought it was the relay switch and changed it but
then there were a few small fuses that were blown to and we changed them
to and it ran good for about a week but now it is doing the same thing
sometimes it will start and sometmes it wont. It will just die ...

I did a valve job on a 1999 chevy suburban, what is the proper procedure
for setting the timing on a 5.7 motor. thank you.

This afternoon driving home from work I noticed my left Daytime Running
Light was out. (Saw the reflection in a vehicle in front of me at a stop
light).
Exactly how do you check the light? The bulb appears to be OK but the only

Anyone know of a dealer or vendor that sell fiberglass truck beds????

Guys,
       I need some guidance. My wife has a 4.3L Jimmy with a TBI. The
engine is getting too much fuel. Runs rough and will not idle below 2.5K
RPM. I can get it to idle below 2K RPM if I unplug one injector. The plugs

Can anyone tell me on my 92 5.7 Silverado exactly where the wire that is
needed to unplug to time my truck is located? Thanks For anyone that can
help.

Here is the deal, I recently replaced my blown up 2.2 with a 4.3L engine, as
I was instructed by many who had done the process before, I was sure to be
able to obtain the BCM and the PCM from the same vehicle that the engine was
removed from.  My truck is a 1998 s10, the vehicle the ...

I have a 1990 Jimmy fullsized 4x4 with a 350 engine and the 700r4 auto
trans. When pulling a car trailer with a car on it, should I put the
trans in  Drive instead of Overdrive? I just bought this last month, and
will be towing with it for the 1st time this coming weekend. The 97 ...