I've got a 2004 Chevy Silverado, 30,000 miles, automatic tranny. Still
under warranty. I've noticed that occasionally, when the truck is
completely stopped, that when I give it the gas, I don't go. Engine
revs, and it takes a second or two for the tranny to kick in, and then

Im trying my first speaker installation on my Dads 2003 2500HD
Silverado reg cab. Were puttin in new speakers...the problem is the
factory harness at the speakers doesnt say which wire is negative and
which is positive. Does anyone know? The connector is labeled A and

I have succesfully removed the door trim panel and the water guard on my
 1997 Blazer 4x4. I have drilled out the rivets that were holding the
windows regulator and the motor. However, I cannot get the regulator
free from the window rails. Is there a special trick for this? Has

I am swapping a 400 out and putting a 350 tranny in and i want to find out
if i have to swap transfer cases also i have a 208 np for the 400.  I have
heard that it will work as is, then i heard i have to change the whole
thing out, and then i heard i can just change the input shaft. ...

93 Suburban 1500 C has GT4/G80 which is 3.73 limited slip differential
axle.  Shop manual talks about several rear axles - 8.5", 9.5",
10.5".... Ring Gears and they all have different lubricant capacities.
Short of dropping the cover, how does one determine which one?

I recently bought a 1986 C10 with the Silverado package. The truck has
305/TH350. I didn't realize until after I bought it that it had a 2.76?
rear gearing. I want this truck to tow my
3100 lb camper. The motor and trans should be no problem except I am

Hi, I'm looking at installing a 2" suspension lift to my 90 k1500.
Looking at the block and torsion bar indexing key type kit.
Being that I've never touched a torsion bar setup before, I'm just a bit
apprehensive about doing this myself.

Our 1992 4X4 2500 has a leaky seal on the transfer output shaft
(according to the dealer). We're currently in Seattle but are heading
back to Detroit (where I can get the work done cheaper) pulling a small
5th wheel trailer. It's a very slow leak, maybe 2 or 3 drops in 24

Our 1992 4X4 2500 has a leaky seal on the transfer output shaft
(according to the dealer). We're currently in Seattle but are heading
back to Detroit (where I can get the work done cheaper) pulling a small
5th wheel trailer. It's a very slow leak, maybe 2 or 3 drops in 24

My emissions stickers and tune up information missing under the hood of my
82 suburban. I bought a Chilton's with the vacuum charts in it. It has all
of them up to 1980 , and 1984 on too . For 1981 it says see under hood label
for vacuum routing and tune-up information. Them ...

Here's the cause of GM bankruptcy:
Geedy Massachesetts lawyers in bed with unions and liberal democrat
politicians who pander to the stupid uninformed voters among us who can't
connect the dots by telling them "you have right to stand up to corporations

If the fuel pump is not putting out enough pressure does the fuel pressure
switch stop the motor from getting fire?

I have a 99 Suburban K1500 4x4.  I have noticed lately that when taking a
slight turn to the right, it will occasional jerk to the right.  Kinda
freaks you out when going around a curve and it does it.  Seems to be
getting worse too.  What would be causing this?

Hi, my name is Erika and i'm a senior at McCann tech high school in the
Automotive department. This year we had to pick a project and complete
it. For my project i decided to replace the 4.3L in my 88' chevy truck,
with a

what kinda mileage does a the 4 cyl manual trans s-10 get say 2000 or newer
thanks eric