We have a 1984 Blazer and the 4x4 wont engage, the shifter wont move.
We had the transmission serviced, but it didn't help this.  Any
suggestions on what to do next?

I need to replace the rear view mirrow on my 1994 S10 pickup.There are
no set screws found were the mirrow is mounted to the windshield.How do
you remove the Glued on mirrow without damageing the glass...Jimmy..TIA

How in the would do you get the door panel off the door latch? I have
removed the armrests and all clips but the pannel wont make it around
the interior door handle.  The inner bezel where the locking mechanism
and door handle are located had a small plastic screw which i removed,

We are taking a 383 stroker engine out of a Camaro and putting it in my 1988
Chevy stepside with 305 TBI.
I was wondering about wiring (ETC. Distributor) How do we wire a HEI
distributor (Accel Supercoil) to an ESC stock 305 distributor ??

I have a door speaker on the driver's side that has popped out of it's
hole and is dangling against the metal cover which sounds really nasty
when I listen to music.  I think if I could get the cover off I could
remount the speaker in it's box and it would be fine.

Anyone know the difference between these two fan clutches, other than
the obvious specs listed below off the rock auto web site.
I have a 92 K 1500 350 engine, 7004R trans with 4.11 gears and
285-75-R16 tires.

I have a 89 Chevy Step Side, Short Box. Over the past six months or so the
tail gate has been getting harder and harder to open til finally this past
week I could not get it to open. I had to use a set of channel lock pliers
to squeeze the hinges to help open the gate. It appears ...

I have developed a washboard feeling in my front end lately.
There is no sign of anything on tires.
It is a slow up and down sensation. at about 10 to 20 miles per hour.
Any suggestions............

vehicle is a 96 Astro van, 4.3 L, engine code W, 130 K on engine. On the
drivers side of the engine is a large aluminum mounting bracket that holds
the AC and PS units. The engine has developed a rather fast drip of
antifreeze from behind this bracket.  All attempts to see where ...

Alright, I just got a 2003 Chevy S10.  In the overhead compartment their is
a part to put a garage opener.  On the outside, their is a simple plastic
button that pushes up and when you push it up, it hits the opener and opens
the garage door.  On my compartment, the distance ...

Alright, I just got a 2003 Chevy S10.  In the overhead compartment their is
a part to put a garage opener.  On the outside, their is a simple plastic
button that pushes up and when you push it up, it hits the opener and opens
the garage door.  On my compartment, the distance ...

2003 Silverado 2500hD, 4x4, auto, 366 ci engine. What are normal tranny temps???
I went on a trip yesterday, air temps in the high 80's, tranny temp stayed close
to 180 to 190. Normal??? What's the prob is there is one??? 36,600 mi
Hippy

How does one modify the rear brakes from drum to disk?  90' Chevy Blazer,
full size (of course).  Any ideas would great.
Thanks
Clay

Briefly my air conditioner quit working in my truck. Worked well and then
one day it wouldn't cool, compressor wouldn't turn. I have checked what
relays and fuses I can, believe it to be slightly undercharge from a minor
leak maybe. I bought a repair kit of 2 cans of refrigerant ...

Does anyone know an independent site that tests the different oils on the
market?  Doug