I just had the rear seal in the transfer case replaced as it was
starting to leak.  Now I can't switch into 4x4 high or auto 4x4, the
light on the push button countinues to blink in any mode except 2 high.
It seems to go into 4 low, but the light keeps blinking.

I'm replacing the rusted out fuel tank and sender/fuel pump mount unit
on my Yukon. The fuel pumps works OK and I plan to reuse it, as I do my
own work.
The fuel pump has a long black fuel filter at the bottom.  To remove

I have over 257000 miles on my blazer. It runs great. But It started to run
rough. My wife took it to a (I hate the word !) mechanic. She has been
before we got married. The truck had a hole new fuel system put on all the
way to the catylitc converter. mind you it cost a pretty ...

Ok...  So I am back to work fighting this damn carb... so here we go
again:
Relevant specs:
Edelbrock 1406 (600cfm) on a 350ci/290hp motor...

I am wondering if any one can advise how to change the serpentine belt
on my 1994 S10 Blazer (with AC). I recently noticed during an oil
change that is cracked all over and should be changed. I do have the
belt diagram but I need help identifying how to release tension to

I have a 88 chev 1500 4*4,  with 4 inch body lift, 350ci,,
anyway,, I have excessive front, wheel wobble,, ocassionally,  but getting
more often, 35's don't help,,, but my question is,, this truck does not have
a steering damper... but it does list one when you go to buy one,

Hi... I posted about this before, but got no replies.
Surely, someone has to make this product.  Why wouldn't they?  As
common as 73-91 Blazers and Suburbans are, and 73-87 pickups, you'd
think surely someone has wanted to add gauges and mount them on the

When I went to adjust the valves for the first time, the #1 intake was
tight; I set at at .018, then about a thousand miles later, it was at
.016 (all the other valves were .018) so I reset it to .018.  #1
cylinder is practically dead at idle, but seems to be running at

Help please. I have a 94 Blazer VIN "W". Problems started when it shut
down on the road. No stumble, or miss, it just shut down. When we turned
the key to on the pump did not run. Towed it home and changed the fuel
pump. It now runs (the pump) when the key is turned to on. The ...

Can anyone tell me a safe way to replace the spring in the door hinge
on my 2000 K2500 truck. I noticed one day that the spring was missing
so I picked up a replacement with the intention of installing it
myself. It looks as though you have to compress the spring in order to

How can you tell if you have a low speed rear end with out the tag for gear
ratio ?

Since I pulled all the wiring out to replace it, I can't remember where
the temperature sensor is.
I thought it was the one on top of the intake manifold, behind the
upper radiator hose neck, but when I plugged it in, the gauge just

I'm looking into getting a newer truck, specifically a 2003 S10 Ext Cab 4x4
with the ZR2 package.  I seen one that a dealer had online that only had 37k
miles on it, with just about everything I'd want on a truck.  I drove the 25
miles to take an upclose look.  When I got there I ...

Will a full time four wheel drive go in any range (4x4 high, low, or 2x4
high) if the front drive shaft is taken out? I heard that it won't, but, I
do not know for sure. Can I put a new front differential with lock outs to
replace one that came out that is full time four wheel ...

Can someone please direct me to the proper TSB or part number for the lube
kit for the intermediate steering shaft for my 2004 CHevy Silverado 2500HD.
I had the shaft replaced under warranty, but the truck now is out of the
warranty period (and then some) and the problem is ...