I have a '94 1/2 Ton 4WD Suburban. The ABS light has gone on and off
from time to time. Right now it is off and has been off for quite
awhile.
My first thought (after being told the price of a new computer) is that

When Applying the brakes, particularly at low speed,(15mph or less) My 97
Yukon nose dives as if there were no rear brakes or the fronts were coming
on much sooner than they should. Adjusting the rears up to drag a bit
seems to help a little but only for 3-4 days and it's right ...

1981-1987 display cluster with rpm gauge ?. I know these are rare.. but
like to keep the truck not too cheeco with a monster tack followed by 10
other cluster bombs all over the dash.. If anyone can find one or knows of
one for sale.. email me.. thanx

Ok, here's the situation.  I just bought a chevy blazer from a used car lot,
ran fine, except for a rattle in the catylatic converter, which they replaced
with a new one before I took the vehicle.  Day one ran fine, day completely
totally dead the next morning, no power, jumped it, ...

I have a '99 Silverado LT 5.3 and the driver's side heated seat does
not function.  The passenger heated seat works.  I have checked the
fuse and the underseat connections look solid.  Any suggestions?
Thanks much.

2003 Chevy Silverado 1500
The oil pressure guage typically sits at about 40 when idling and
moves up a bit under throttle.
The other night, it started sitting on ~80 with the engine off and

I have a 95 Chevy 1500 with a 350 motor and manual transmission; it has
120k miles on it.  Under heavy acceleration a metallic grinding noise
is very noticeable and the check engine light comes on.  As soon as you
stop accelerating the noise goes away and the check engine light goes

My 88 S-10 Blazer 4.3 serpentine belt lasted a year..then my alternator
starts rattling...it went after about a year and a half...that must have
been what shredded the belt!I replaced the tensioner...it's still pretty
tight..guess things only last a year or so.

Could one of you nice folks tell me where the codes are on a 89 Blazer and
90 4X4 Pick-up front rears? Both are 4X4 S-10's and 4.3 automatics. I could
use some help so I don't have to pull the covers.
TIA

I bought 2 trucks. 1, 1981 3/4 ton bo lo 4x4 3/4 ton 4 bolt 350 engine,
and a 305 tbi 1987 2 wheelie peely..  I am putting all the wiring from the
1987 into the 1981, pulling the 4 bolt 350 (propane powered all her life)
with bo lo tranny and putting a 700R4, 1992 ,350 tbi in it. ...

I have a '99 Silverado LT 5.3 and the driver's side heated seat does
not function.  The passenger heated seat works.  I have checked the
fuse and the underseat connections look solid.  Any suggestions?
Thanks much.

I am working on rebuilding a 1989 Full size Chevy Blazer and I need to find some suppliers in Canada for body parts and panels.  The body of my truck is really rough and really even like to find somewhere to get a better body frame work to start from.
Any help would be great.  ...

my chevy silverado 1989,?700r4 maybe,,, is not shifting 2nd, perhaps
3rd gear. This truck in automatic, C2500 and when in drive it goes
maybe about 40 miles/hr max. Engine is fine also I have changed tthe
speed sensor, I thought that was the problem because it was cracked.

On my 93 Chev G-30 1 ton with 6.2l Diesel, I cannot figure out how to
install the anti-rattle or inner pad spring clip on Bendix front brakes.
I didn't think I was that stupid, but I just can't see how it goes.
Any one have a diagram or picture, or a very detailed explanation.

94 chevy 3/4 ton during first start up oil pressure is good. after 1 hr of
driving, pressure is way low. Check gauges comes on, oil level is good.
changed oil an filter an oil sending switch. but no improvement. is my oil
pump slowly going out.