Last year I was in a pretty serious accident in my Chevy S-10 (crew
cab).. I wasn't hurt but the truck took a lot of damage ($10,k +) and
when I went to switch in into 4WD this past week (nasty weather in the
Pittsburgh area) I wasn't sure that my 4WD was even working... which

Ok,
Here's my problem.  I'm having an issue with the power steering being
hard to steer at an idle once the truck is fully warmed up.
Truck is stock with 350 engine, I've replaced the OEM P/s pump

I'm leaking coolent from behind the tin nut on the trans cooler line. I
tried to snug it up some but it didn't help. Does anyone have a fix
besides takin it to the shop or buying a new radiator? Does the fitting
that the trans line goes into un screw from trans cooloer tank?

I was wondering if someone who knows for certain could tell me where the
fuel pump relay is in a 95 Jimmy?  This model has the relay pack in the
glove box however...
According to MOD Online, the relay is under the hood beside the A/C relays

I have an extended cab and the rear doors have bad rust on the inside bottom
seam.Anybody experencing the same problem? Please check your suicide rear
doors.

I have a 2006 Yukon Denali with the 6.0 engine with 12K miles. I recently
started hearing a knocking sound when the engine is cold. Has piston slap
been reported on these engines? Please tell me no since I have this with my
Expedition.

I have a 2003 Silverado with 6.0.  When in 4wd, rather than the front
end pulling the truck around the turn, it pushes straidght through the
turn.  It acts to me as if the rear tires are spinning faster than the
front.  I have searched everywhere and knowone has been able to help

I want to change out the headlights  on my 01 Silverado to a brighter one
Next to My wife's Lexus with hd lights I have flashlights for headlights.
and need brighter lights as I do a lot of driving in Deer Areas. Any
suggestions would be appreciated

Looking for  warn m-21 hubs.  For my 3/4 1959 napco GMC truck.  late
57-59 will work  
Thanks
Jeff

I have a 03 Silverado and took it in for a noise in the trans I thought and
they had a couple of service bulletins.  They replaced the rubber at the top
of the strut towers, and regreased the steering wheel shaft where it comes
together around the u-joint in the shaft.  It did ...

I have a jerking problem going down the road at any speed. Before that
it was missing, I had the wire, plugs, dist cap, rotor and coil
replaced. The miss was still there. The mechanic replaced the Fuel
meter body and that fixed the miss. Now it has a jerk at any speeds.

Do the V8 mounts line up with a straight six or is it a different mount
altogether?  If they needed to be changed, would cutting and/or welding
be required?
~jp

well i just had my 89 4.3 bored 0.040 over......started right
up...looks sharp by the way
all black engine nestled in a white engine compartment.....(man did i
scrub that sh.t)

The speedometer and odometer recently stopped working on my 1983 Chevrolet
Suburban. Inspecting the speedometer cable's connection to the
transmission (TH700R4, automatic) I discovered a plastic gear (see photo
at http://srcopan.vze.com/part.html) with stripped teeth. There is no

Hi, I am intersted in putting a 6.2 diesel in a 75 El Camino alomg with
a 700R4. I have the engine and trans and am going to look at a
supposedly nice EC body tomorrow. I thiink they were available with 454s
so I assume the 6.2 would be about the same size and weight. Any