My '99 2.2L Sonoma -- 96K miles -- has developed a rattling in the
exhaust.  I put it up on stands and listened to it and, sure enough,
its coming from inside the catalytic converter.  After it cooled off I
shook it by hand -- theres the sound of something rattling around loose

I don't know how, but I have managed to loose the keys to my ignition on my  
1990 Chevy 1 ton 4X4.  I have a spare door key, that's all.  The lock smith
wants $65 to $75 to come out and hopefully make a new one.  Does anyone
know of any other more ecconomic options?

My '95 G20 Van is showing a lot of rust around the lower extremities..
years of salt up here in Maine.
Has anyone tried some of these replacement pieces that are generally
available? It's a work van, so not a lot of cosmetics are necessary,

I am looking for some help on fixing the starter problem on my truck. I have
a 1993 GMC 1500 Z71 with the 5.7 engine, it has about 133,000 miles on it. A
few weeks ago I had a new flywheel put on as the old had worn spots in it and
was causing the starter to grind. After the new ...

I have a 1997 Tahoe with 5.7L engine and only 87,000 miles on it.  A
couple of years ago my mechanic discovered a rust covered sludge when
he took off the radiator cap.  That cost me a new radiator and he
warned that the intake manifold gasket would probably need replacing.

anyone here doing anything extra to help their "BABY" resist/fight off
RUST?
my '82 is showing rust signs and i am FREAKED OUT!!
im thinking of dressing her in RUST BULLET primer and adding a RUST STOP

Does GM still use Decks-Cool in it's new vehicles?

Hi,  I am haveing trouble locating a large coolant leak on my 96 GMC
Sierra.  It is running off of the starter bolts on the P/S of the
vehicle.  Any one have any suggestions where I may want to look?  I
have read the posts on the intake manifold gasket but the top of the

I am a newbie and recently purchased a '99 Suburban K1500 and it feels like
its all over the road.  I am always correcting it even when going straight.
Does anyone else have that problem?  I already checked the tire pressure in
all tires, but it still drives the same.  Any help ...

Hey guys,
I have a '84 K10 Suburban with a rochester carb and 350 engine. When I
start the car for the first time in the morning it starts at a low
idle. Just a little faster than curb idle. Obviously this causes the

I am a new owner of a beautiful 1998 Suburban, have a problem and need
help - as there aren't any Chevy dealers here in Slovakia :D
The car runs without any Problems as long as in 2wd mode. No noise, no
nothing, just enjoying the ride... The switching into 4hi or 4lo as

The handle pulls up, one side seems to be unlatching (I think) but the
other is just plain stuck and is not budging, if I pull the bedliner
panel off, will I be able to access the mechanism to the handle back
there to fix the problem?  What is probably the cause?  thanks!

I have a 01 Silverado with a little overv 100000 miles on it.  Very
occassionally, say every few months, I get hot air coming from the
vents and cannot get it to turn off.  If I turn the A/C on, it still
blows hot.  If I turn the truck off, usually for 15-30 minutes, it will

I just purchased a 1999 USFS K2500 4X4 Suburban at auction.  The front seat
is trashed.  It wouldn't be so bad except that it's a bench seat and I can't
find one.  Everything seems to be buckets.  What other models use the same
seats?  Trucks, Tahoes?  And are the welded nuts ...

Does anyone out there have a '68 or '69 truck which came with a 396 stock?
And if so what is the timing advance spec?
According to Haynes the '70 version is set at 4 degrees btdc. But GM only
put the 396 in the '68 and '69 trucks. After that it became a 402.