| Thread | Last Post | Replies |
|
| 1997 Chevy Silverado 2 Questions Electrical Problem & Intake Manifold Gasket | 11 Feb 2007 01:40 GMT | 4 |
Truck has 133,000 Vortec 5.0 2 wd Ext cab SB Any one experience this: In warm weather, with a/c on, I hear the signal flasher relay is clicking. When I hit the brakes it stops. Happens randomly ....mostly
|
| Tips on carburetor Rochester | 10 Feb 2007 16:11 GMT | 1 |
A friend of mine have a Chevy '56 short block 256 ci V8 engine with a two barrell carburetor with the following reference number on a small green aluminium plate: 7027114
|
| 1978 ignition switch replacement | 10 Feb 2007 12:58 GMT | 3 |
Can anyone tell me how to remove the ignition switch on a '78 4x4 1/2 ton with tilt wheel? When you put the key in the ignition, it will just turn in circles. It locks normally with the key out. Thanks.
|
| Voltage | 10 Feb 2007 05:06 GMT | 20 |
2007 Chevy Silverado Classic 5.3L 4x4 Voltage Gauge Fluctuates between 12.8-15.25 Check with a DMM and voltage to agree with the gauge. Dealer explained as a Regulated Voltage Control System, is this just a fancy
|
| need help on 99 5.7 timing and p1345 | 10 Feb 2007 04:09 GMT | 23 |
I changed the intake gaskets and I got the distributor in exactly as the book says. Engine runs but reports P1345. Scan tool shows timing advance at 22 degrees and engine idles nicely after an initial correction.
|
| mine does this too except worse | 09 Feb 2007 03:21 GMT | 4 |
I have a 94, vortec and it has no power at all. what it does is when you hit the gas too hard it spits and sputters but if you back off of the throttle it will slowly pull. If you hit a hill its like you hit the gas too hard again. but at idle its complety fine. I cinda think
|
| 2001 silverado spark plugs | 09 Feb 2007 02:34 GMT | 2 |
How the heck can I get the plug wires off they are seized on the plugs. I have tried various pliers to no avail. Do they make a special plug wire tool for this engine?
|
| Trailblazer Remote | 09 Feb 2007 01:04 GMT | 3 |
I had to replace a door lock/unlock remote control. I followed the remote control program and I now have a #1 and a #2 remote acting as a # 1. The seats, mirrors, radio and heat adjust differently by the # 1 and # 2 signals. There is a #1 and # 2 on the back of the remotes. The ...
|
| Windshield wiper problem | 08 Feb 2007 23:49 GMT | 2 |
Had a huge sleet storm recently. I thought I got all of it off the wipers. I turned them on and the passenger side wiper was still stuck. Before I could turn it off, the other wiper went, and the passenger one broke loose,
|
| 2001 silverado sparkplug question | 08 Feb 2007 22:33 GMT | 1 |
re: 5.3 01 Silverado 4x4 How the heck can I get the plug wires off. They are seized on the plugs. I have tried various pliers to no avail. Do they make a special plug wire tool for this engine?
|
| Turn Signals in Mirrors | 08 Feb 2007 19:54 GMT | 3 |
I wanted this feature because I thought it would be a great safety addition, WRONG. Night time driving, add some rain to the picture and the drivers side mirror blinds you and makes it where you can not see anything in the mirror.
|
| Chevy van fuel pump | 08 Feb 2007 03:18 GMT | 17 |
I want to chane the fuel pump on my Chevy van to electric. Its a 1985 G20 with a 305 and quadra-jet. The trouble is the existing fuel pump has 3 hoses. I assume one goes back to the tank(a return). No electric pumpthat I know of has this extra connection. How can I make the ...
|
| 2000 Silverado Defrost | 08 Feb 2007 01:42 GMT | 8 |
Does the A/C compressor run in defrost mode in these new generation trucks? Mine doesn't. Is it normal or do I have a problem? Thanks; Mike T
|
| Starting troubles | 08 Feb 2007 00:43 GMT | 3 |
:cry: I’m having trouble locating the starter relay on my 95 Silverado :x Any help would be great. :P A wiring diagram would be very helpful :D THANK YOU |
| manual choke 1967-8 quadrajet. White lightning | 07 Feb 2007 23:58 GMT | 2 |
Ok I have a rebuilt quadrajet (7027156) and it works fine. It sits on top of a 396 in a 1968 GMC truck. It is set with a manual choke. Very simple setup. I set it up according to specs.
|