I have a 1989 Jimmy 4x4,4.3(v6) auto.186100km. I have had it since new so
it is in good shape. But this is what I have done to try and fix it.
Replace fuel pump, gas filter, new tank, new wires from GM, new plugs, map
sensor, EGR value, and EGR solenoid, new coil, new TPS, cap and ...

my brake lights do not come on when i press the brake light the only
light that does come on is the third brake light, the brake lights do
come on when headlights are on, could anyone please tell me how to fix
this problem

As I understand it, the winders in the '02 2500HDs go up and down using a
cable system. Is this correct? What is involved in replacing them? I have
not pulled the door panel yet for a visual of the issue, but it is making a
noise much like gravel is in a track scraping and ...

I have an 88, S15, 4.3, Auto, 4x4, with 197,000 miles that's driving me
crazy (crazier??)......It runs fine when cold.  When it reaches operating
temp and it's driven at around 40 to 50 mph, it feels like it's cutting out
electrically.  It happens for a second and then will be ok ...

I'd bet a dollar to a nickle the dealer would tell me so.  "Can't fix
something that ain't broke!"
Yep, the beginnings of the creepy cruds you see on old motors that were
never washed.

I ahve a 97 Chevy suburban that died on me today...completely lost power
everything. Well, it'll crank but it wont start. Replaced the fuel filter
thining that was the problem....you can hear the fuel pupm working when the
key is in the on position so didnt think that was the ...

I just found out at www.claimsreporter.com that apparently most Insurance company policies require the use of certified factory parts for collision repairs.  They also said that most repairs have no warranty unless issued by the repair service and not the Insurance company!  Does ...

Dose anyone have the wiring configuration for spark plug wires from
the plugs to the distributor?  I have a 97 GMC 350 engine.
Thanks in advance.
Ray

I removed a zip tie on rear axle assembly while replacing it, now I
can't remember where it goes.
I think it held the e-brake cable still, but can't remember.
Can anyone tell me?

Hey guys,
I believe I have been having a problem with my Mass Air Flow sensor fouling
my plugs, is this something anyone here has seen before.  The engine misses
a little, lacks power under 2K RPM and the transmission will slip once in a

On my engine my harmonic balancer is loose and it makes this squealing
noise like really loud and i wonder if it's just my balancer that's
just loose or do i need a new crank. it's in a 1985 cutlass supreme
with 40 seris flow masters 4" tips and elderbrock carb,intake and

A number of people have remined me I stated the wrong horsepower. Its not
horsepower, 454 cibic inch or 7.4 liter.  Big deal, It's still a 1996 Chevy
P30 chassis with what ever engine it came with.  And not one of the
smartass' offered any suggestions on locating the electric fan ...

I recently bought a 1985 Chevy 4x4 van.  This is my first big 4x4 (i had a
toyota and an old beater subaru before) so I'm not real familiar with Chevys
or anything like them.  The problem's that because it's a van and it had to
be converted to 4wd after it came off the line so ...

I have a 1998 GMC Sierra 4x4 Z71 that I purchased about a year ago.  
It has 287k on the clock, but is in incredible condition.  Runs like
a top, looks like a new truck and is clean as a whistle.  However,
the cruise control has recently begun acting up.  It works sometimes,