| Thread | Last Post | Replies |
|
| changing coolant 97 K1500 350 | 25 Mar 2007 14:46 GMT | 1 |
I was going to replace my coolant today but I'm having trouble draining the radiator. There is a little white plug[?] with a tee type handle that I can't reach on or near the bottom of the radiator on the drivers side . I assume that's for draining the radiator . I ground a
|
| Rear View Camera System | 25 Mar 2007 06:12 GMT | 2 |
Hi all.... I'm going to install one of those wireless rear view camera system in my 02 Silvered 1500 HD this weekend. The instruction says to tie the wiring for the camera into the back up lights, but I'd rather have the camera on at all
|
| 2004 GMC Instrume nt Cluster Self Test | 25 Mar 2007 05:52 GMT | 1 |
Is there a way to trigger a self diagnosis of the instrument cluster of a 2004 GMC Pickup? I know with some Fords I can hold the odometer reset when I turn the ignition switch to "run" and trigger a instrument cluster self test. Is there anything like this for a GM
|
| please help me figure this out | 25 Mar 2007 04:48 GMT | 8 |
my 91 chevy 4x4 runs strong when hot and when cold but not in between when warming up. It bogs from about five minutesa of running to about ten min. I don't know what sensor controls this as they all show good on the diag. port. The only one that showed is the " esc" sensor but ...
|
| truck parts for sale | 25 Mar 2007 04:15 GMT | 1 |
96 chevy vortec k&n cat back system (new) 96 chevy vortec air filters (new) chevy center caps (new) 2" drop shackles for a 88 to 98 chevy p/u (new)
|
| is there a tbi aftermarket intake to convert old sbc block to tbi ? | 25 Mar 2007 02:00 GMT | 3 |
I know they make a carb intae for the tbi but what about the tbi to old school pre 1986 blocks ?.. I have an awesome 350 4 bolt main to drop in but can't find an intake.. thanx for any advice.. OH for all you "why bother" .. The truck has to be e-tested up here and Carb is a ...
|
| '91 Suburban Kill Switch | 25 Mar 2007 01:49 GMT | 2 |
Alright guys, due to some recent breakins at my apartment complex I have decided to install a hidden kill switch in my Suburban. I've narrowed the location down to either the starter, the coil, or the fuel pump. I was told by a friend that if I attached it to the fuel
|
| 2002 S-10 Blazer clicking in dash | 24 Mar 2007 22:25 GMT | 4 |
A constant clicking noise started in the dash board of my 2002 blazer recently. It makes the noise both stopped and when moving. It has around 80,000 miles. Any ideas?
|
| Chevy 1500 88 or 89? And what engine | 24 Mar 2007 20:30 GMT | 3 |
I am trying to figure out if a prospective free truck is an 88 or 89. It says on the door that it was manufactured in 05/87...does that mean it's an 88? I am curious because I think the engine needs a rebuild. It has done
|
| engine running issues. | 23 Mar 2007 20:25 GMT | 5 |
What would cause a 4.3 v6 to when under heavy throttle stutter ?.. but if you accelerate slow it runs fine ?.. I am assuming fuel filter or bad fuel prs regulator.. but thought I would ask the guru's here..
|
| Warning Light in G20 | 23 Mar 2007 19:43 GMT | 3 |
my 1992 Chevrolet G20 Van http://www.xs4all.nl/~imxtreme/Chevy/8-more.htm has a problem. Some weeks ago, the batery was drained due to a little interior light
|
| Need some advice from the hardcore Chevy fans. | 23 Mar 2007 14:43 GMT | 4 |
Alright where do I start? Well, I'm planning on buying a 1989 model Chevrolet pickup from a friend of mine. It's a regular cab, short wheel base with a 5.7L 350. The truck sucks.
|
| Centering Steering Wheel | 23 Mar 2007 02:00 GMT | 12 |
Had truck aligned now steering wheel is not straight. How do you adjust? 2007 Chevy Silverado
|
| Clutch Disk Replacement | 23 Mar 2007 00:54 GMT | 7 |
I have a 2005 Silverado 2500HD with the Duramax Diesel & the 6sp manual transmission. The 6sp manual may be a bit old fashioned, but I enjoy driving it. I tow a 13,000 pound 5th wheel RV behind the truck about 1/2 of my
|
| 1998 Blazer Catalytic Converter | 23 Mar 2007 00:20 GMT | 3 |
I had a exhaust rattling on my 1998 Blazer. My local Chevy dealer said the catalytic converter is rotting out & causing the rattling. They give me a price of $425.00 to install a new one. They also said that it could break up to the point that it could plug up the exhaust ...
|