I have a 2000 Sonoma with power windows and power mirrors. The switch(es)
for the mirror seem to be bad as the control for the mirrors is erradic at
best.
Can someone tell how the panel that the switches are mounted on is removed?

Can run the blazer in idol for a couple hours, no problems... bu
driving it ... at about 60 - 65 miles just stops.
First time it happened there was a blown fuse. Replaced the fuse
turned the key, fuse blew again. Had the blazer towed to a garage

I scanned the truck and get a DTC P0300 Random Misfires. So far I changed
the sparkplugs, Bank2 Sensor 2 oxygen sensor also had a DTC P0161 code. I
also changed the fuel filter. I also added a can of fuel cleane and took it
on a long ride. No difference. I get the misfire once the ...

Power antenna does not retract but motor runs when radio turned on or
off.  Shop manual shows that the antenna mast can be removed but has
no information on motor drive servicing.
Can the power antenna drive be dismantled/repaired.  Are parts

Lately I have been using my 4 Wheel Drive because we are experiencing
snowy weather. However, when I try to take the Blazer OUT of 4 wheel
drive, it doesn't go out real easy and makes a loud humming noise and
the finally a huge BANG that shakes the front and then it is out. It

I have an 01 Jimmy that has the 4 button setup.
On the left is the large button AUTO 4WD
on the right is 2 Hi   4 Hi and 4 Lo
I have always used 2 Hi except when it snows and I need the 4x4 engaged

looking at buying a 1998 tracker looking for opinions i owned a 92 before &
liked it
thanks

on the ford forums won't help or give rude replies.. That's ford owners
for ya LOL  Can anyone tell me what the symptoms of a ballast resistor ?.. I
have a 1994 Mustang 3.8 (JUNK I know) it starts and runs not bad but I can't
rev the engine or do squat till it runs for about 3 ...

Where is the fuel pump relay located on the 1994 Chevy S10? My book says
it is in the glove box, but it is not there. The book also says that it
is under the dash center console, but it is not there either. I
purchased a new relay because the fuel pump is ok. I hooked a jumper

I own  a 2004 Chevy Express Cargo Van and don't know how to replace a burned
out front directional signal bulb.  The bulb cannot be accessed from
underneath the hood, and there are no screws on the exterior lens cover that
surrounds the bulb. I believe that the exterior cover has ...

Changed out my ring and pinion today in my truck. went from a 3.23 to a
3.73. Everything went smoothly. but
i noticed there is a howl or a wine when you are cruising about 40-50mph
with your foot barely on the gas, doesnt do it when you let off, doesnt do

Hey guys...This lady is in need of help...I had the motor rebuilt in
my 89 Chevy Suburban...Thats all good. But now when I start it and it
warms up to about half it will die. And it also wont shift into 2or 3
not really sure which one when it warms up. Does any one know what

I have started my first solo rebuild on a big block 396 that used to
belong to my Dad.  So far the heads are refusing to come off.  I don't
want to get too rough with them for fear of damaging the gasket surfaces
or cracking them.

hey guys i'm new here but heres my fun, i'm replacing the head gaskets
on a 1999 chevy blazer 4x4 i have everything lose but the dang fuel
lines that go into the back of the tbi are really giving me problems
what is the easiest way to get them off besides cutting them????

I have had several rear window wiper arms on my '99 Suburban.  They all end
up sticking and not pressing on the window.  If I pull them away from the
window they have all stuck in that position.  Does anybody know of an
aftermarket arm that actually works?