I am having a problem with the Drivers side rear brake/turn signal
light lighting up, I have replaced the bulbs but that had no effect,
it gets power at the harness and my parking lights work fine. Can
anyone help clarify what is wrong with it, I have checked the fuses

my 94 s10 blazer had the left turn signal spring fall out (didn't know
what the spring was for when i found it near my feet, until noticing
later on that the turn signal left wasn't cancelling). Anyways, do i
really need to use the steering wheel puller to get the steering wheel

   I am killing myself trying to get solid verification on the O2 sensor
location/s for this vehicle (see subject line).  I have replaced the O2
sensor at the Œy¹ collector pipe just upstream of the cat but I¹m wondering
if there¹s another that I should hunt down and replace?  My ...

53K miles just started making a clunk around corners but intermittent
and not on straights. Is this just a standard rear end that I can replace
the spyder and axle gears and live happily ever after? I used to own a 70
Camaro and had the same thing happen, replaced those 4 gears and ...

I noticed that the coolant level in my radiator rises and falls very
rhythmically. It seems to be very consistent in it's tidal movements and
appears to coincide with a fluctuating temp gauge.
This problem (?) first appeared when I had the heater hose fitting on the

91 K1500  5.7L 168K
I am getting coolant leaks at the intake manifold.  I am wanting to change
the gaskets, but I remember a posting where there was a better/upgraded
gasket set made.  I just don't want to have to do this twice.

Well, I finally went and done it. Bought the 02 2500HD  LS 4x4. 6.0
Gas. Crew Cab.
Have been needing a good 3/4 ton truck to tow my camper, and the time
was right financially, so jumped on one.

Yes I have the dreaded intermitent wiper problem with my truck. I bought it
new and as long as the sun is shining they work great but as soon as it
starts to sprinkle they wont do anything. I am looking for the part number
and retail store that sells the improved replacement circuit ...

I have purchased a 1999 GMC Sierra which needs brakes all around. I
would like to upgrade the brakes to something incremantally better
than the stock brakes, but I don't need high performance.
I'm planning to spend about $150 per wheel for rotors and pads and

Possible Solution to Astro Van 97, 98, 99 Starting Problem. If you
have the following symptoms, this may apply to you.
-For years my 98 Astro Van had trouble starting in 'cold or wet
weather', or damp weather, especially when there was fog, or heavy

I have new crome for 1955 -1958 Chevy truck .
front and rear bumper
front crome grill  very high grade nickel plate.
Call Ken 706 321 1771    706 324-1085.  Just make me an offer

I'm trying to r/r power steering hose on a 95 gmc k1500 (not hydroboost)
and I can't seem to find wrenches to fit the hose nuts. 3/4" is too big
5/8" is too small.....starting to sound like Goldilocks. Anyway, what size
and type wrench is going to break these things loose without ...

I'm trying to r/r power steering hose on a 95 gmc k1500 (not hydroboost)
and I can't seem to find wrenches to fit the hose nuts. 3/4" is too big
5/8" is too small.....starting to sound like Goldilocks. Anyway, what size
and type wrench is going to break these things loose without ...

Hi everyone, I'm new to the site. I came across it when trying to figure out
why my 87 chevy pickup 350 EFI,,,refuses to start. A member named Pode had
the same exact problem I was having. Here's what he said:
   This motor normally starts with out a hitch.  When I

On my 2003 S10 4.3 liter (52,000miles) when I accelerate around 2 to 3
thousand rpm's I get a rattle. I can put into park and slowly run up to the
1800 rpm area and hear it.  It sounds similiar to pre ign noise. Could this
be the timing chain tensioner? I asked the dealer about ...