Have a 1987 S10 ; the seat belt on the passenger side will not extend - it
comes out a few feet and "sticks", making it useless but for dwarfs and my
cat. I see it retracts into a plastic case - but the case seems to lack
screws or any other method I can see to open and work on ...

Hey Newsgroups,
I recently bought a used 2002 Chevrolet Tahoe. When standing in a
hill, the handbrake is not strong enough to keep the car stopped. I
looked through the Internet for any plans on the handbrake but

I want a decent carb for my 327 but am not to sure about the 650 dbl pump
carb I have and how it would perform.. I have a stall converter th350 /327
bored 60 over performer PM intake combo so  need a bit of advice on what you
guys would use..  I also have a 750 VS carb but it ...

The fan on my '95 Tahoe will suddenly stop anywhere from a  few seconds
to days.  Sometimes I can get it to restart by hitting on the fan unit
under the dash.  There's no bearing noise--it sounds like an relay or
something electronic on the fan motor.

I have a 92 Z71.. My Oil stick has started to rust. Fact it has been rusting
for a bit. I went get a new stick but hey did not have one..
I thought I would go buy a  salvage yard and get one..
When I check my oil there is little rust specks in the OIL.. Fact lots of

Hello group,
I'm in need of some ideas, my truck is as follows:
1999 silverado, 4.3 vortec V-6, 5 speed manual trans, 100000 miles.
I get a hesitation when I apply small amounts of throttle, If I push the

Good day,
I have a 1995 Astro which quit for no apparent reason. I found the PCM fuse
blown, replaced it and it starts and runs good. Idles for a few minutes,
fuse pops again and thats the end of it...

I have bought a used GMC 2500HD, Duramax and would like to know how to tell
what engine is in it,LLY, LB7.  I would like to chip it and that is why I
need the info. Thanks

Anyone out there got one?

Anyone know what code reader to get that will read transmission and abs
codes on a 94 GM 1 ton. Thanks.

I'm in the market for a new truck and was thinking about going to look at an
04 Colorado.  I happened across a website that gives an estimated cost for
timing belt replacement of $1,750 ...is the right?  ...and do they need to
be done every 60k miles or so?  Any info appreciated, ...

I rebuilt the front end on my truck (new ball joints, tie rods, u-
joints, etc.) including the calipers and rotors along with wheel
cylinders on the back about 8 foot of new brake line new rear rubber
brake hose and a new master cylinder.  Now, the peddle is very, very

I am trying to replace the drum brakes on the rear, but there is no
plug to remove.  Instead there are 2 slots that seem solid.  I am just
trying to remove the drum so I can replace the brakes.  Any help would
be great.  Thanks.

i have an 03 2500hd and the brake lights will not function, the the
3rd light on the roof does?
wtf? is that about? i traced all the lines, and the bulbs and the
fuses and just about evey inch of it i could, and still nothing.

The CHMSL on my daughter's 96 Blazer has not worked since she purchased the
vehicle used 2 yrs ago.
I don't have a manual for it, so don't know if it's part of another circuit
in the fuse panel (though I did not find any burned out fuses in the panel).