Home | Contact Us | FAQ | Search & Site Map | Link to Us
Sign In | Join | Other 45 Sites in Network
HomeAnnouncements
Discussion Groups
By Brand
BMWChevroletDodgeFordGMHondaLexusMercedes-BenzNissanPeugeotToyotaVolkswagenOther Brands
By Topic
4x4 CarsRVsDrivingMaintenance & RepairCar AudioCollectible Cars
Country Specific
Australian ForumsUK Forums
ArticlesAuto InsuranceBuyingCars & TechnologyMaintenanceMiscellaneousSafety
DMV Resources
Related Topics
MotorcyclesBoatsMore Topics ...

Car Forum / Chevrolet / Chevrolet Trucks / July 2007

Tip: Looking for answers? Try searching our database.

ThreadLast Post  Replies
Tranny Swap27 Jul 2007 08:34 GMT16
I have a 1988 Chev with a 305 and a TH400 tranny. I want to know if it
possible to put an overdrive tranny like a 4L60 or 4L80 from about th
same year.
I know it would involve a different crossmember, mount, driveshaft
question27 Jul 2007 07:31 GMT5
i have a 92 chevy s-10, my fuel pump is going out,, can that effect my
ac
Bypassing the dvd while in drive27 Jul 2007 03:25 GMT13
Is there any way  to disable the function that kills the dvd screen in the
console while in drive. I certainly dont want to watch Finding Nemo, but my
kids are fine with the screen in the rear, but my wife gets bored only
hearing the sound and not the movie.
Question about retroing a vehicle Any help?27 Jul 2007 01:29 GMT1
I would like to take a late 70's to mid 80's chevy truck and retro it
as far as removing all electronics.  Is that possible? Return the
truck to a 'points' system, etc.
Also, can you take a truck which is not 4x4, and remove a 4x4 system
chevy 350--- target master engine?????26 Jul 2007 19:49 GMT1
hi i just bought a 350 motor and i want to know some about it......
it
is a 4 bolt mains motor because i checked... heres the #'s  back
flange behind head drivers side cast # 3970010 and 41 GM ...... bck
87 Sierra S15 firing order?26 Jul 2007 02:52 GMT3
my book says that the firing order for my v6 is 165432  where #1 is
driverside nearest front of vehicle.  I changed plugs, distributor cap
rotor button and the truck  wont start. It backfires back through the
thrittle body and spits/ sputters. This makes me believe that I have a
Homemade removable 3rd seat?26 Jul 2007 00:12 GMT2
My 83 Suburban has two bench seats, but I really wish it had the removable
3rd bench seat. Sometimes I haul lots of people and sometimes I haul lots
of gear. If I were in Chevy country I´d scour the junk yards for one, but
there aren´t any junked Suburbans or Blazers down here. So ...
chevy 35025 Jul 2007 18:54 GMT1
hi i just bought a 350 motor and i want to know some about it......
it
is a 4 bolt mains motor because i checked... heres the #'s  back
flange behind head drivers side cast # 3970010 and 41 GM ...... bck
Speed-o25 Jul 2007 04:59 GMT2
Hello, I changed my 3.73 rear end to a 4.10 on my 98 Silverado and now my
speedometer is out, how would I go about changing it?. Thank you.......Ed
remote door locks - 99 Yukon25 Jul 2007 04:21 GMT1
I have a problem that I would like some opinions on.  Sometimes, when I hit
the door unlock key on my remote(factory), the driver's door will not
unlock(you can't even hear it trying to unlock).  Other times, it works
fine.
TAILGATE24 Jul 2007 23:30 GMT2
1994 CHEVROLET 1500, TAILGATE WILL NOT LOCK ON LEFT SIDE. I HAVE OILED,
GREASED,CLEANED LOCKING THINGEE. ANY SUGGESTIONS WILL BE APPRECIATED.
OPENING LEVER WORKS FINE, RIGHT SIDE SLIDES INTO LATCH PERFECTLY, LEFT SIDE
WILL NOT MOVE IN ENOUGH TO GO INSIDE LATCH. TAILGATE RATTLES ...
1988 Checy C1500 - "popping" in muffler & runs rough24 Jul 2007 23:28 GMT7
Vehicle:
1988 Chevrolet C1500 2x4 with a 4.3L V6 & standard tranny
The truck was in perfect condition, then was in a fresh water flood
where it was completely submerged under water for about an hour.
1983 305 problem24 Jul 2007 23:23 GMT2
After driving a long distance and shutting the engine off it doesn't want to
crank?
It's like the timing off, the engine turns VERY SLOW but always starts??
I have had to waite a few mints but it always starts?
2002 Express Van Seat Locking Pins24 Jul 2007 05:34 GMT1
Anyone know where I can get seat locking pins for the bench seats?
They install on the floor to lock the seat down. Looks like maybe a
dealership item? Thanks.
1983 305 starting problem24 Jul 2007 00:31 GMT4
I made this post already and one person answered by saying a shim was
missing from the starter!
Did you mean to say it only showed up when its HOT?
--------------------
Pages: 1 2 3 4 5 6 7 June, 2007
 
Sign In
Join
My Latest Posts
My Monitored Threads
My Blog
My Photo Gallery
My Profile
My Homepage

Start New Thread



©2008 Advenet LLC   Privacy Policy - Terms of Use
This website includes both content owned or controlled by Advenet as well as content owned or controlled by third parties.