Anyone have a good parts source for 99 and newer Chevy/GMC tuck parts,
mainly lookng for interior right now.

1995 Chevy Silverado Z71 4X4 Ext. Cab 5.0....Sometimes my wipers seem to go
to far and get stuck in that position. A little nudge gets them going again.
Other than that they work fine. What would cause this? Thanks for helping...

Does anyone make a conversion kit to go from the rear disc brakes to drum
brakes?
TIA

Just checking to see if anyone has a recommendation on cold air intakes for
the Silverado. I had an AEM unit on my 2001 Silverado (4.8liter) and that
seemed to work well. Just bought a 2007 Classic (1500HD) with the 6.0 and
would like to install one as well. Tempted to stay with ...

2001 Silverado. My truck drains the battery after 3 or 3 days of no driving.
I replaced the battery and checked everywhere. I can find nothing on that
could be draining the battery. Any suggestions?
Rob

I have a 1999 chevrolet s-10 blazer. The power window on drivers side is
making clunking sounds when activated in either direction up or down.

Hello, I recently wired the electric brake controller for my trailer . I am
getting no juice from the wire that my pre wired 2007 Suburban LTZ came
with. While reading my owners manual, it staes that the 2 circuits that the
control the brakes and aux wires to my trailer are fused ...

Just curious: does the brightness of the light give any indication as to the
strength of the spark?

I've been a Chevrolet owner since 1967.  There is well more than
one reason for that, but one of them is because I take pride in
being an American, and I thought Chevrolet did to.  Yes, even
though the name has some connection with a French influence from

How diffiicult are these to replace?
Just paid over $500.00 at the dealer to have the right one done and
now I can hear the left side begininng to whine.
I just had the ball joints replaced.  Would the bad ball joints cause

Hello, I'm new here. I'm hoping someone can help with my problem.
My vehicle is a 2000 GMC Sierra 1500, 2WD.  Last July/06, I had both
front and rear rotors machined due to brake pulsation - this corrected
the problem.  At that time the milage was 67338 miles.   Since then

I have an 89 k5, 350. tbi, stock. The plug wires for this truck have 90
degree boots at the plugs, which ground out through the insulation at
various points even with the use of wire looms. Particularly at the heat
riser. Is there a plug wire set with straight plug boots I can ...

Hey there, I recently had some work done to my rear differential
(pinion seal & axle seals). After it was put back together I noticed
there was a leak around the cover on the differential. I removed the
cover, drained the oil, and put a new seal on. However, I noticed

anyone know what paint is good for exhaust manifolds? i need to pain
some ramhorns and want the finish to last. would bbq paint hold up t
the heat?? i hear the regular exhaust paints just burn off real quic
--

I am thinking about filing a class action lawsuit against
Chevrolet for knowingly installing substandard brake
rotors in 200X Chev HD pickup trucks. Mine has 24,400
miles with soft rotors beyond refurbish specs. Most of