| Thread | Last Post | Replies |
|
| 1998 Blazer Keyless entry question | 31 Oct 2007 04:47 GMT | 2 |
Does anyone know how to program the keyless entry for a 1998 Blazer? I don't want to pay the dealer $50.
|
| 2004 Trailblazer Headlights. | 30 Oct 2007 21:50 GMT | 3 |
Does anyone know if it is possible to disable the function that turns the headlights on a 04 Trailblazer on automatically.
 Signature -------------------- http://NewsReader.Com/ --------------------
|
| Chevy Tahoe O2 sensor | 30 Oct 2007 18:40 GMT | 1 |
Can an O2 sensor cause my Tahoe to run rough?
|
| Help!!! Advice needed, 4.3 liter engine head gasket in a 96 Astro van | 30 Oct 2007 17:25 GMT | 25 |
Posted to alt.trucks.chevy, rec.autos.tech, alt.autos.4x4.chevy- trucks Subject: Help!!! Advice needed, 4.3 liter engine head gasket in a 96 Astro van
|
| 93 suburban 3rd row seat mounts | 30 Oct 2007 16:21 GMT | 3 |
I just got a 3rd row seat from a salvage yard along with the seat belt harnesses that hang from the roof. My truck never had a 3rd row seat, but the 2nd row had flip-up things for it and I noted that the roof had plates over where the seat belts would hang from. My assumption
|
| troubleshooting ignition circuit | 29 Oct 2007 20:57 GMT | 1 |
How do you hook an electronics type oscope to check yor ignition. Ive used an oscope before that was made for automotive troubeshooting but it has been a long time. I think you hook the vertical to the points side of the coil and sync to the first spark plug in the order. Is this ...
|
| Intermediate steering shaft? | 29 Oct 2007 15:56 GMT | 1 |
Apparently there is an upgraded steering shaft. Does anyone know the new UPGRADED part number? My dealer hasn't heard of an upgraded part. Thanks, G
|
| Axle shaft movement | 29 Oct 2007 00:19 GMT | 2 |
Just replaced axle shafts on my 1970 C-10 with 12 bolt 3.73 rearend. The replacement shafts are the exact same length and spline count as the old ones. Also replaced bearings and seals. How much side to side play should there be when the vehicle is off the
|
| Click When Turning Only | 28 Oct 2007 18:27 GMT | 4 |
When turning at low speed, my 2000 Z71 has a small tick that can be felt through the steering wheel. I has 60,000 easy miles on it and the tires have always been rotated at 5,000 miles and hand torked. Feels like it could be a wheel bearing with a flat spot on one of the
|
| weird windshield washer | 28 Oct 2007 06:10 GMT | 7 |
97 Chevy 1/2 ton. Windshield washer sprays, but spray doesn't come out with enough force to reach the windshield. Blew out the lines with the compressor. Checked the washer spary nozzles (clear). Blew backwards through the line to make sure no restrictions. Checked the
|
| 88 S-10 Blazer 4.3 Windshield wipers Question? | 28 Oct 2007 02:31 GMT | 7 |
Can anybody tell me why my windshield wipers come for no apperent reason.Some times they come on with just turning the steering wheel other times when I turn on signal lights?If it is the turn signal switch it's self. Did they improve the design on these in later years?Because I
|
| 2001 silverado 4x4 backing plates | 28 Oct 2007 00:38 GMT | 6 |
I am going to have to replace the cheezy backing plates on the rear axel they simply rusted away . Has anyone else had to do this and can you give me some tips. I have a positraction rear end TIA
|
| 02 S-10 Ashtray | 27 Oct 2007 22:44 GMT | 6 |
'02 S-10 Extended Cab I went around and around with the service dept at Fisher over this. One of my guys broke the little plastic clips that hold the ashtray assembly in place in my S-10 service vehicle. I asked the svc dept to order the clips
|
| 1985 Suburban steering prob. | 25 Oct 2007 12:16 GMT | 1 |
I just replaced the steering gear box on my 85 4wd Suburban. The problem is the steering is locked up. Before I installed the rebuilt box , I checked it out . It worked fine then.. well I recoonected the pitman arm and now it is locked up , can't turn or anything.... yes I
|
| S-10 Heater Core Removal | 25 Oct 2007 03:48 GMT | 3 |
how to remove heater core in 93 chevy s-10? i got cover screws out. cover will not come off due no clearance. TIA j.b.w.
|