I have a '98 Sonoma with the 4.3 V6.  It has 143k miles on it, and I
have never had any problems with it.  In the past couiple weeks
though, I heard a tapping noise like metal against metal when
accelerating from a standstill. Now there's not just the tapping, but

Can anyone tell me exactly where to find the electric fuel pump fuse
and relay for the above truck? Also, which pins to bypass on the relay
for a test? I parked it and it is no longer getting fuel (did a fuel
pressure test and got zero). I want to rule out the electronics before

hi gents
I have a 2005 silverado and it's out of warrenty and there is a knocking in
the front end.I was told it was something to do with the sterring column.
It;s not the first time it does this. Does anybody lnow if there is an after

Hi everyone,     I have a 1993 silverado 2x4 5 liter auto. recently a
check gages light came on.This is seperate from the check engine light,I
have never seen this light before. I was hoping someone might be able to
tell me what it means and what I can do about it, Thanks

Anyone have any insight into a source for wiring diagrams for an S-10
pick-up?  Just picked up a used 94, 2.2, with lots of wiring problems. Have
a Haynes manual for it, but that isn't very detailed. Would like to find a
website that has good info on this vehicle, or a book will ...

I've got a 94 suburan with with 298,000+ miles. Original engine uses no oil.
replaced transmission at 195,000 (daughter burnt it towing horse trailer in
O'drive)
replaced rear axle at 250,000 Rear bearing spun & ruined axle housing.

I have a 2000 Chevy silverado Z71 4x4 with a 5.3L. About 50% of the
time when I start the truck the voltage guage only reads about 10
volts. When I hit the street and rev the engine up the guage jumps to
14 volts or so. I have replaced the alt and battery and cables. Anyone

I have a '99 Suburban with the 454 (7.4L) engine and the belt needs
replacement.  Looking at the service manual, I am confused.  The manual
shows a tensioner on a pulley arm.  My vehicle has a tensioner mounted
on the rim of a disk (?) that in turn is bolted to the engine.  It

This 1996 2.2L 4 cyl Sonoma wont start. I checked and found no compression
at all on 2,3, and 4 cyl and almost nothing on 1. Took off the valve cover
and found the valve trane working, seemingly ok. What could be wrong?
Thanks for any help.

All:
I have had a persistent vibration commencing at 66 MPH and continuing from
there thru 80MPH. I don't (won't) run faster than that. The Yukon has
120000 miles and had the transmission replaced with a GM Certified rebuilt

Two problems have recently started with the 4WD. While driving down the road
the indicator lights on the dash will switch over to the 4 HI light from the
2 HI. Pushing the switch on the dash always takes it back to 2 HI. I really
do not think the transfer case switches as there ...

Can anyone tell me exactly where to find the electric fuel pump fuse
and relay for the above truck? Also, which pins to bypass on the relay
for a test? I parked it and it is no longer getting fuel (did a fuel
pressure test and got zero). I want to rule out the electronics before

Does Anyone know where I can get a new Volume knob for my radio on my
Silverado?

I have a 1996 Chevy K1500 Pickup with the pushbutton 4 wheel drive.  The
front will not lock in and the light on the dash just blinks.  I pulled the
actuator and connected to battery and it extends.  I checked voltage on
connector and had 12v but when I plug the actuator in, the ...

Just as my '01 Blazer (4.3L) was turning 127,000 miles today, the
"Service Engine Soon" light came on.  After shutting the vehicle off
and letting it sit for about a half-hour, the light did not appear
again at the subsequent start up.  I do have a cheapie OBD II reader