| Thread | Last Post | Replies |
|
| 2004 Silverado Front End Clunking | 15 Dec 2007 00:14 GMT | 11 |
My truck (2004 Silverado LS) has recently developed this apparently universal problem. It has 57K miles, and DID NOT have the problem when I bought it used in April. So my question is this: Is this a safety issue, or just an annoying
|
| $40us HID, Hot Sale Now | 14 Dec 2007 02:31 GMT | 2 |
Hello everyboday. I have a really good products to recommend you guys. it is HID. The color temperature is from 3,000K to 30,000K. Pink, green, gold, pure blue colors are also available. From Dec. 13 to Dec. 25, It just cost you $40us/kit, That is a very very very good deal.
|
| help with wiring on 94 chevy blazer | 13 Dec 2007 22:23 GMT | 2 |
I've been having problems with the fuel pump not kicking in (see below in the group) I think I tracked down the problem to a loose connector under the dash, probably something left over from a bad car alarm installer (the
|
| 98 jimmy speaker question | 13 Dec 2007 13:43 GMT | 1 |
I want to install speakers into the top dash area where factory speakers were not installed. I opened the covers and found wiring and tested them , they work. what size fits into the opening or how do I measure them.
|
| Resistor Pack for fan contol | 13 Dec 2007 00:25 GMT | 1 |
Trying to replace the resistor pack that controls fan speeds. Lost all but the highest setting. Any clues on where this is located ? 2003 Tahoe. thanks,
|
| Front axel seal replacement | 12 Dec 2007 21:42 GMT | 11 |
Just got a 1979 K20 and the right front axel seal is leaking really bad. How big of a job is it to replace those seals? Thanks for any advice given!!
|
| 1980 Chevy G20 Won't Start | 12 Dec 2007 01:54 GMT | 6 |
I have a 1980 G20 Van with the 5.7L V8 that I cannot get to start. I have replaced the distributor, coil, rotor, and spark plugs and get good spark. There seems to be plenty of fuel getting into the carburetor, but even with starting fluid I cannot get the engine to fire.
|
| 1994 k1500 5.7 has no low end power | 11 Dec 2007 23:59 GMT | 2 |
my truck has no power at low rpm untill about 3500 rpm then runs strong. The exaust sounds different but it is not pluged ive done a tune up plugs wires cap roter air and fuel filter checked the timeing and put in a tps, map senser ignition modual none have made any difference. ...
|
| 03 Suburban Trailer Brake | 11 Dec 2007 01:41 GMT | 2 |
I have an 03 Suburban 1500 which I recently purchased that has the towing package. Today I connected a trailer brake controller to the trailer 6-way slot on the instrument panel block and noticed I wasn't getting any power to the brake controller (no light on controller when
|
| 98 Chevy Suburban K2500 Cooling system questions | 10 Dec 2007 19:12 GMT | 4 |
I have a 1998 Chevy Suburban K2500 4x4 (7.4L gas) with 117k miles. The radiator developed a crack in the oil cooler tank right beside the upper oil cooler fitting. So, it was time to replace the radiator -- and while I was at it the water pump, thermostat and upper/lower ...
|
| Stalling | 10 Dec 2007 19:03 GMT | 1 |
I have a 93 Blazer,6cylinder,just tuned up. Starts up fine idles great,But; stalls when put into gear. I need help ASAP please. -- Message posted using http://www.talkaboutautos.com/group/alt.autos.4x4.chevy-trucks/
|
| '95 Tahoe Question | 09 Dec 2007 20:01 GMT | 1 |
Does a 1995 Tahoe 4X4 have the same acuator switch as my '88 K2500?(just screws in the housing) If not would someone let me know where it is located and ease of removal.
|
| 98 Chevy Suburban Oil Cooler Line question | 09 Dec 2007 05:21 GMT | 5 |
1998 Chevy Suburban K2500 4x4 454 engine (gas) My suburban has a coolant leak at the upper oil cooler line fitting going into the radiator. There is a stamped tin nut that holds the fitting and leak appears to be coming from around this nut.
|
| 2004 silverado stereo | 09 Dec 2007 02:28 GMT | 6 |
stereo sounds good for stock (bose) but none of the controls work except off/on and volume. lights come but cd will not eject or ff or stop or nothing short of pliers to get out. quick fix or do I rip it out? thanks to anyone in advance. c
|
| "06 Silverado, driveline clunk | 08 Dec 2007 15:35 GMT | 10 |
Anything out there on drive line clunk in a '06 Silverado, 4X4? Clunks when shifting from drive to reverse. Dry slip yoke? Anything else? Thanks. Greg
|