Home | Contact Us | FAQ | Search & Site Map | Link to Us
Sign In | Join | Other 45 Sites in Network
HomeAnnouncements
Discussion Groups
By Brand
BMWChevroletDodgeFordGMHondaLexusMercedes-BenzNissanPeugeotToyotaVolkswagenOther Brands
By Topic
4x4 CarsRVsDrivingMaintenance & RepairCar AudioCollectible Cars
Country Specific
Australian ForumsUK Forums
ArticlesAuto InsuranceBuyingCars & TechnologyMaintenanceMiscellaneousSafety
DMV Resources
Related Topics
MotorcyclesBoatsMore Topics ...

Car Forum / Chevrolet / Chevrolet Trucks / March 2008

Tip: Looking for answers? Try searching our database.

ThreadLast Post  Replies
98 blaser stuck in 4wd07 Mar 2008 20:04 GMT3
read recent treads on this done all of the above. disconnect battery
ect.. i tried changing the TCCM that did not work...fuse is good...all
connections are good...already replace 4wd vacuum actuator 1 monht ago
replace 3 line vacuum switch on trans fer case becuse it stuck open
failed smog test...hydrocarbons06 Mar 2008 14:33 GMT7
My 93 k1500 with a 305 won't pass smog. It tests 5 points too high on
hydrocarbons. I have replaced plugs, wires,cap,rotor and o2 sensor. Anyone
have any ideas????
--
Chevy S-10 truck blower problem06 Mar 2008 13:46 GMT8
I have a new issue with my truck blower, it only blows out the defrost
vent now and will no longer change when I turn the switch. It still
blows heat and AC but only out the defrost vent. I have heard this is
probably a vaccum problem but don't know where to look, or could it be
down shift06 Mar 2008 05:10 GMT1
i have a 94 1500 4x4 with a 350 and a 4l60e trany it has no low power and
and i have to floor it to get it to down shift i think the engine is fine
but is it possible the torque converter is locked or if you have any ideas
thank you
'91 S10 radio wiring diagram06 Mar 2008 01:55 GMT2
1991 Chev Blazer S10, nearly 400,000 km on original motor!  We're
looking for a wiring diagram for the radio, which finally sputtered
and died, and am replacing it with an am/fm/cd player from Canadian
Tire.  Installation instructions leave much to be desired.  Wiring
Throttle Body Linkage06 Mar 2008 01:53 GMT2
Ok, so I need to replace the TBI unit on my 89 s10 4.3 4x4. I can't
seem to find anywhere describing how to remove the TV cable or
Throttle cable. I'm sure it is easy enough, but both my shop manuals
just say "remove the linkage". Any help??
1989 k-1500 rear differential issues06 Mar 2008 01:27 GMT3
hey everyone,
got a u-joint replaced today and the mechanic noticed a lot of play in
the rear end yoke.  He suggested getting it replaced asap!  He also
said it wouldnt be a bad idea to get the pinion bearing and seal
Radio antena connect 94 K1500?05 Mar 2008 18:19 GMT4
My tunes quit in my 94 K1500 Silverado.  Amp
works, tape deck works, just static on
radio.  Acts like the antenna isn't hooked up.
WHERE does the antenna plug in?
NV4500 to Detroit: best way?04 Mar 2008 18:05 GMT2
Has anyone out there put a NV4500 on a inline 53 Detroit?? NO ONE
seems to have done this.
Cracked housing on 1996 Tahoe04 Mar 2008 03:31 GMT5
350 v8, 1500 4x4....any ideas on what would cause the
housing to crack?  Cracked between pan and end of
unit all the way around.
94 z71 Trans shifting while in low range04 Mar 2008 02:28 GMT1
I am looking at purchasing a 94 z71.  The quesion I have is: Is the
trans supposed to up shift while driving in 4x4 low?  When I put it in
low range, the trans never shifts up when i drive it.
Thanks.
rcmp gone wild02 Mar 2008 20:22 GMT2
take a look at this video , a guy gets beaten up by rcmp for not putting
down his camera. youtube
" fort mcmurray charter "
89 chevy k1500 starting hard01 Mar 2008 18:40 GMT6
The last few days my truck has been starting hard and sometimes the
starter is very noisy (almost sounds like teeth clashing).  I put a
brand new starter on it in the summer.  Surely, it couldnt be worn out
already could it?
Program door locks?01 Mar 2008 04:05 GMT1
I know this has probably been on here a hundred times before, but can anyone
tell me the procedure for entering the program mode for the remote door
locks and the procedure for programming them? I had one go bad and got
another on ebay now I need to set it up. 2002 Chevrolet Venture ...
Pages: 1 2 3 February, 2008
 
Sign In
Join
My Latest Posts
My Monitored Threads
My Blog
My Photo Gallery
My Profile
My Homepage

Start New Thread



©2008 Advenet LLC   Privacy Policy - Terms of Use
This website includes both content owned or controlled by Advenet as well as content owned or controlled by third parties.