I have a 2003 S-10 purchased new which now has only 16000+ miles.  The
"Service Engine Soon" warning light has come on for the second time.  The
first, with appox 5000 miles around 2003, I called the dealer for help.  He
said probably bad gas, keep driving until almost empty then ...

I have a 01 Silverado with 150,000 miles on odo. Lately when I turn to the
right or left and wheels are turning I hear a squeaking/creaking type noise
from the front end. This happens only when wheels are turning and are being
turned left or right. It happens in and out of gear. ...

Truck, three days ago, was driven and warm. It was shut off at a
store. Came out and it wouldn't even turn over. Could hear the
solenoid click when key turned on. But no turning the engine
over. What could it be? New plugs, plug wires, distributor cap,

I recently spilled gas inside my van. Could someone tell me how to get
rid of the odor? PLEASE!!!!

If I wanted to buy a 350 to biuld up to eventually put into my truck, does it
have to be thew same year as my truck (1995) or will any 350 just slide in?

I store my 2003 Silverado 1/2 ton over the winter.  I drive it
occasionally when the roads are dry, maybe putting on 500 miles in 4
months.  Once in awhile I back it out of the garage to get it out of
the way then let it idle a few minutes to let the oil and coolant

Are you interested to find out how you can have your car running on
water?
http://tbmcars.googlepages.com/car_running_on_water_is_water_4_gas_scam

I have a 1993 Silverago with a 5.0 TBI.  It was idling rough so I replaced
the plug wires, distributor cap and rotor botton (which was badly worn).
After replacing now the engine will not start.  I checked a wiring diagram
and have followed replacing the wires to the correct ...

My 95' Tahoe has lost its last upper dash mount.  These are the mounting screws boss' that hold the dashboard just below the
windshield located in the defroster louvers.
Are there any aftermmarket fixes? LMC truck has the dash for $999. but I was hoping that some one has a fix ...

I bought the wrong crank for my 350 and installed it. The truck was sold to
me as a 305 but then we discovered it was a 350 after the crank was already
in with heads rods etc from the original 350. Would it need to be balanced,
or would it work fine? Thanks.

   Thanks to new Technology, based on an
old patent you can improve your milage by up to 50%.
It's a new version of "Brown's Gas", and works great on gas & diesel
vehicles.
Have a look at what the website below has to say. Many people are using this

What is involved in changing the driver's side front axle shaft oil
seal. I did the passenger side but the drivers side looks like the
diff. has to come apart or does the axle shaft tap out of the housing?

What is involved in changing the driver's side front axle shaft oil
seal. I did the passenger side but the drivers side looks like the
diff. has to come apart or does the axle shaft tap out of the housing?

Just bought a 4x4 Colorado with the standard 15"x6.5" wheels and 235/75R15
tires.  The offroad package has 265/75R15 tires on 15"x7" wheels which look
much better on the truck.
Can I put 265/75R15 tires on a 15"x6.5" wheel?  If not, what's the biggest

Hi  To all:
Got a 2002 Chev S-10 -2 WD-that needs new front rotors. When I change the
rotors and hubs, Will install new seals but what about bearings...should I
get new ones or are the old ones reusable?