03 Silverado 1500 w NP8 transfer case and 5.3 L motor.
DTC code C0306 is set.
2WD/4WD shifting is disabled and 2WD light on switch panel is lit.
Using procedures in GM manual, encoder motor seems ok, but found

I am happy to answer your question. When you floor the gas pedal, you
engage the "kickdown gear." The purpose of this gear is to rev the engine
which also revs the water pump to keep the engine cool. Otherwise the
engine "lugs" and this overheats the engine, causes "pinging" and can ...

I've got my eye on a 91 Suburban 4x4 with a 6.2 Diesel in it. Anything wrong
with these engines. Ive not heard much about these engines. I heard the
block head bolt holes  crack, but Ive heard others say they are good
engines. Any chronic known problems, or is this vehicle just a ...

I recently was given an 8000 pound Warn Winch for my 4x4.  An 07 2500HD Crew
Cab.  I have been looking for a good way to mount it that will be effective
when I need it, look decent, and not cost a ton of money.  Eventually I
would like to put on the big Warn winch bumper, but I ...

Anybody know of someone who can custom tune a 4 cyl  2.2L Chevy 2002 ECM ?
Seems like the 4 cyl is a problem to tune for some reason.....
Truck is an S-10 with 5 speed.
Thanks, Pete

Need some help choosing a cover for my truck. I've been considering the GM
part number 19213900. An example can be seen here:
http://gmparts4u.com/scripts/prodView.asp?idproduct=300170
Does anyone know how this installs? I cannot find installation instructions

Japan is a leading provider of vehicles around the world; Japanese
vehicles used & new are always high in demand. But the problem is very
few people understand how to get them imported to there country. Here
is the complete explanation to all the queries:

Ok, I narrowed my battery discharge problem to 2 fuses under the hood and 3
inside the cab. Under the hood, pulling the lights and the battery fuses
eliminates the drain (pulled the positive cable and rigged up a light bulb
in line between the battery and the cable). Inside the cab, ...

I have a 94 C1500, 350,auto that runs on low voltage with lights and a/c on.
Engine idling with no lights or a/c, no problem, shows 14 volts on the
factory gage.
Engine idling with progressive amounts of load, a/c, low, med low, med hi,

2 problems with my '98 'Burb:
- Front diff got fried by a bad tow and I'm not confident
 in the repair - and getting stuck on the beach is a
 stone bummer (muuuuy expensivo tows... predatory, even)

My 2000 GMC has started to have a very strong odor of natural gas
coming from the front.  If I drive with the windows open even a
little, it comes pouring in.  Windows closed with or w/o the a/c on,
absolutely nothing.  Really weird, it is the *exact* same smell of

My 2001 Silverado C1500 has never gotten over 19 MPG, and 19 was only
once on a long highway trip when I wasn't in a hurry.  Usually it gets
about 15 or 16 in the summer and 11 in the winter. (I think part of the
problem is the oxygenated gas they sell up here doesn't have as ...

I got a Class  3 1981 Chevy Suburban  thats 8600 lbs.GVW .  Ive owned a it
and have it insured for over 5 years. It Gets 10 mpg on a good day, Id love
to trade it in on a new or used truck. But the pricks say its too old.  So
I'm going to retard the timing and spew  hydrocarbons out ...

Can the pan gasket on a 99 Silvy 5.3L be replaced with out lifting/
pulling the engine?

135k miles on mine. At far left or right turn there is a rubbing/
squeaking that happens.
Dealer says steering gear is going bad and wants $950 to replace! WTF?
Can I attempt to replace on my own? Anyone else familiar with the