| Thread | Last Post | Replies |
|
| Repair cost question | 03 Jun 2005 02:48 GMT | 3 |
It's decision time for me. How much should I expect to pay to have a new alternator installed in my 1987 T & C wagon? How about a new valve cover gasket? Thanks.
|
| 2001 Minivan - power steering locks up | 03 Jun 2005 02:15 GMT | 3 |
My wife drives a silver, 2001, chrysler town & country minivan lxi. If you look closely, there is about 20 of them in the mall parking lot right now~ 2 wheel drive. 3.4 liter. Here's the problem. When first starting the power steering freezes up,
|
| To clean valves | 03 Jun 2005 01:20 GMT | 7 |
What should I use to clean noisy valves ? Is it save for engine to use it . Plymouth Acclaim 92 , 3.0L 260K km. ( runs well ) Thanks Chuck
|
| Jeep Grand Cherokee 5.7 Hemi in UK | 02 Jun 2005 22:23 GMT | 5 |
Here is a review in today's UK Sunday Times of the new Jeep Grand Cherokee. http://driving.timesonline.co.uk/article/0,,12929-1630542,00.html I have reproduced the article below my signature for convenience. What do you think? Agree/disagree, bearing in mind the European context?
|
| WTB: 1961 Newport Parts/Chrome | 02 Jun 2005 21:52 GMT | 5 |
Does anyone know of a good outlet for parts related to the early 60's Chryslers? I have a 1961 Newport that needs a few chrome pieces and some tail lights, esp. I am not finding the usual repro trunk liners, carpets, etc.
|
| Help: Recharging AC on 96 G Voyager SE | 02 Jun 2005 20:40 GMT | 6 |
I read in the Haynes manual when I recharge the AC system with very low Freon I have to short a switch/sensor for which turns on the compressor but it does not tell in detail where this is located. Can somebody who has had to this on my model or similar model point me in
|
| trouble changing CV joint ( half shaft) 93 Grand Caravan | 02 Jun 2005 19:31 GMT | 2 |
I have to change the CV joints on the driver side of my 93 Grand Caravan. I have the tie rod disconnected. I'm trying to the get ball joint out so I can pull the hub out away from the splinned shaft, but I just can't get the ball joint to go down enough to come out.
|
| Stalls after fixed time | 02 Jun 2005 18:50 GMT | 13 |
My Plymouth Acclaim (1992, 4 cyl, 127k miles) got a new fuel pump 2 weeks ago, when it wouldn't start (after sitting overnight). That apparently solved the problem, since it wouldn't turn over at all before the new pump. A few days later there was a new problem. It stalled after ...
|
| Power Windows Problem on 2000 Dodge Caravan | 02 Jun 2005 05:31 GMT | 6 |
I'm having intermitient problems with the passenger door power windows on my 2000 Doge Caravan. Sometimes the window will not go up or down. Hitting the middle of the door panel causes the window to function properly (jars the motor and/or the tracking mechanism)
|
| Air Conditioning (A/C) Trouble | 02 Jun 2005 04:24 GMT | 5 |
I'm really hoping that someone out there can help me find a solution to this problem that I'm having with the A/C in my Jeep. I recently purchased this Jeep, so I don't know much about its service history. The problem is that the A/C compressor only kicks on when the control
|
| stereo problems caravan | 01 Jun 2005 02:51 GMT | 2 |
I have a 97 Grand Carvan SE that has the infinity stereo system. The factory cd went on it so I had a new sony cd/mp3 player put in. The problem is that it doesnt sound near as good as the original deck. It is a high powered Sony deck but sounds "tinny" little base. Are there
|
| stalling | 01 Jun 2005 02:27 GMT | 7 |
put an engine in my car it has 82,000 miles the car is a 94 lebaron conv. it stalls when under load at stop lights when i step on the gas at the rpms hit 4500 the engine just goes to nothing like 1500 rpms when i let off the gas it is ok shifts fine but in that rpm range the engine ...
|
| dodge ram transmission please help.. | 01 Jun 2005 02:08 GMT | 1 |
I have a 8cyl. dodge ram 4x4 with an automatic transmission. Out of the blue it started to shift really hard into overdrive. It seems to really rev, and then shift really hard. It makes the dash shake when it shifts. It doesn't always do this. All the other gears are fine, and shift ...
|