I recently took a trip to Louisville which was seven hours away. Going
to there, the Cruise Control worked fine, but on the way back when I
tried using it abruptly it stopped functioning in the middle of
driving. I would like to know what solutions there are for this. I

If i leave it parked in the sun the temp is always about five degrees more
than after a few minutes driving.
Bud

same old same old.tranny stuck in 2nd gear.replaced both input and out
put sensors changed tranny fluid and filter,same problem.was told it
could be the tran control module .i believe it is located on the
drivers side fender wall,under the hood and next to the battery.it is

So I spent $200 and had the "detailed" inside and out before shipping it to
my in-laws.  I used to wax and in later years put NuFinish on my cars, but I
have to say they never came out like this.  It is incredible.  Maybe I
should keep it.  LOL.

I have a question for the group.  I have a 91 Plymouth Acclaim with a 3.0L
and about 255,000 miles.  It's been a good car but it has developed a
problem that is driving me crazy.  When you accelerate with the car, at
about 38 mph the vehicle starts to shimmy.  This continues ...

Can anyone offer advise on installing a combination switch in a 1999
Concord

I'm replacing the Oxygen sensor in my 1995 3.0 Acclaim.  I have read on
here that the Bosch unit that everybody sells is not good for my car.
None of the Napa dealers near me carry the Echlin unit either.  I was
wondering if the Denso unit I can order is any good?  I'd rather pay 35

I AM HAVING TROUBLE KEEPING TIRES ON OUR 2005 CHRYSLER 300.
I HAVE HAD IT LESS THAT 1 AND 1/2 YEARS AND ALREADY HAVE PUT ON TWO
SETS. AND IT IS NOT BECAUSE OF ABUSE EITHER. THEY ARE JUST WEARING DOWN,
EVEN THE DEALER IS PERPLEXED WHY THIS IS HAPPENING, ANYONE HEARD OF

Type of car.. 1991 lebaron 3.0
My car is HARD to start (now) before it was running real sluggish..
acting like it wanted to stall out (actually did stall out).. but only
while driving it (steady pressure on the gass peddle)  when it started

I want to install some reversing sensor to the above vehicle.
Does the rear bumper have a metal frame within the plastic moulding?
The reason is I need to thread the sensor wires around and along the
inside of the bumper and also drill 20mm holes in the bumper to fix

Bill Putney has me nervous.  The steering wheel is slightly crooked after
getting the clunk repaired but I hate to get the car aligned and wheel
straightened and risk someone not knowing how to handle the front end of an
LH car during an alignment messing up the bushings again .  ...

1998 Voyager, 3.0L engine, 4speed auto, 83,000 miles, regularly
serviced: Experienced very mysterious set of circumstances this past
Sunday, 2/19/06 (the coldest day yet this winter in Philadelphia, about
25 deg F).  I drove about 14 miles, hiway speeds, before I noticed that

Hello All.... Got a '94 Van with the airbag light on.  Can someone
give me some info on how to troubleshoot this.  Location of sensors,
retreiving the trouble code.  Thanks for your help.
Neil

What's involved with changing over to them? I noticed a 300M Special in the
junk yard and was wondering how complicated it might be to install them in
my 300M.
What should it cost for the parts?

For some reason the clock in my 1999 300M stopped working. I checked
all the fuses, but there doesn't seem to be one for the clock. Does
anybody know how I could remove the part of the dash that contains the
clock so I might check for a loose wire?